ICF10B

l/min O2. After this heat treatment all specimens were scrutinised as to their microstructures, residual stresses, wear, and corrosion properties which in detail is reported elsewhere [4, 5]. Table 1: Chemical Composition of the Martensitic High-Nitrogen Steel X30CrMoN15 1, 1.4108 = AMS5898 according to the Steel Manufacturers Specification. Fe C Si Mn Cr Ni Mo N bal. 0.25-0.35 < 1 < 1 14-16 < 0.5 0.85-1.1 0.3-0.5 Fatigue Testing and Fractography The fatigue specimens were cut out of the lasered discs by mechanical wet cutting and afterwards machined and ground on all areas - except the laser hardened surfaces – (Figure 1). It has to be noticed that two types of specimens were provided. One group contains specimens of 12 mm width, which comprise the hardened zones, only. The second group of 16 mm width embody the tempered zones as well. These bars were loaded cyclically in a 4-point bending (4PB) test device (Figure 3), which was mounted within a servohydraulic test rig. The load range of the constant stress amplitude tests was chosen between 225 and 630 MPa at 20 Hz and an R-value of 0.1. In order to carry out tests in artificial sea water (3 % NaCl in aqua dest.) at room temperature the specimens were placed inside a rubber tube. This set up allows a continuous flow of the artificial sea water brought about by a small aquarium water pump. The water temperature was measured by a thermocouple and scattered between 20 and 30 °C. Under both conditions (dry/3%NaCl) the specimens were fatigued to fracture and the results were plotted in Wöhler-diagrams (S-N curves). Afterwards the fracture surfaces were investigated in making use of a scanning electron microscope. 60 30 10 12 16 width, all measurements in mm RESULTS AND DISCUSSION Microstructure and Residual Stresses Figure 4 shows the results of the microstructural examinations after a series of laser heat treatments at different maximum temperatures [4, 5]. At about 950°C the surface hardness and the cm/am-ratio, which represents the tetragonal distortion of the newly generated martensite, increase. The hardness reaches its maximum value slightly above 1000 °C as a result of the increasing distortion of the martensite. Above that temperature hardness decreases by the governing influence of the increasing amount of RA, which is markedly stabilised by N. According to the nature of the temperature field one has to distinguish between Figure 3: Test Rig for Cyclic 4-Point Bending in Air

RkJQdWJsaXNoZXIy MjM0NDE=