The deformed area of the microbeam was thinned by FIB machining to less than 0.1 µm to facilitate transmission electron microscopy (TEM) observations. The observation of dislocations was carried out with a Philips CM 200 type TEM at an accelerating voltage of 200 kV. RESULTS AND DISCUSSION 1. Cyclic deformation behavior The mean deflection δm ( δm=( δmax+ δmin)/2) of the microbeam at the first cycle was set to be zero ( δm=0), therefore, during cyclic loading if the microbeam moves downward gradually (the compliance of the beam increased), which is associated with the cyclic strain softening or cracking behavior of the material, δm will become negative. On the contrary, δm associated with the cyclic strain hardening behavior, will become positive, as schematically illustrated in Fig. 3(a). Figure 3(b) shows the variation of the mean deflection δm of the microbeam with cycles at both load amplitudes. It can be found that at ∆P=40 mN, the material initially experienced cyclic strain hardening and then cyclic hardening reached to a stable status gradually. The SEM examination on the top surface of the microbeam at the fixed end after 4.5×105 cycles exhibited that no microcracks initiated. When ∆P=47 mN, the material also exhibited the cyclic hardening behavior, but the ma xi mu m δm is hig her tha n that at ∆P=40 mN. With increasing cycles, δm decreased gradually after 2.0×10 5 cycles. The decrease of δ m was identified to result from microcrack initiation and propagation in the material, as reported in the next section. 0 5 101520253035404550 -2 -1 0 1 2 3 4 5 6 Microcantilever beam Load ratio R = 0.15 Frequency f = 10 Hz ∆P = 40 mN ∆P = 47 mN Mean Deflection ( δm) / µm Cycles (x104) mδ 0< mδ 0> mδ Cyclic Loading = 0 (b) (a) Figure 3: (a) A schematic illustration of the variation of the mean deflection; (b) The variation of the mean deflection with cycles at both different load amplitudes. The stainless steels with grain sizes from several hundred microns to several tens of microns at a low strain amplitude usually exhibited primary cyclic hardening followed by cyclic softening [7]. At a certain strain amplitude, primary hardening was followed by cyclic softening, which was then followed by secondary hardening. However, in the present study, only cyclic hardening was found in the fine-grained material at two load amplitudes. Figure 4 shows a comparison of dislocation microstructures before and after cyclic bending. Before deformation, the material showed a rather low density of dislocation, i.e. almost free dislocations (see Fig. 4(a)). But a high density of dislocation and strong interaction of dislocations within the grain could be
RkJQdWJsaXNoZXIy MjM0NDE=