would happen in the bubbles first, which would lead to both the increase of temperature and the inflation of the volume of bubbles. On the other hand, the ionization produces many electrons with high energy, which collides with the molecules of the liquid, makes the liquid ionize and produces more bubbles. With the growth and birth of the bubbles, the Bubble Bridge would finally be formed between the crack surfaces, and the electric breakdown would occur locally. Moreover, the electric breakdown occurred in the bubbles would get off light and sound. Therefore, the theory on electric breakdown can be used to explain the experimental phenomena including the occurrence of bubbles, the buzz, the black crack surfaces as well as the sparking. Fig. 3: Optical micrograph of a microcrack Distribution under E=0.8Ec observed by microscopy with 50 multiplication. Another important phenomenon was that crack growth has two patterns in ferroelectrics under electric cycling. One is the case of the low electric field, i. e. E , in which the macroscopic crack stoped growing after it grew a little bit, and many microcracks in front of the macroscopic crack tip were found by microscopy. Furthermore, these microcracks would grow with the increase of the cycling number. The microcrack distribution near the macro-crack is shown in Fig. 3. Another crack growth pattern is corresponding to the case of high electric field, i.e. E , in which only macroscopic crack propagated and no micro-cracks were found as shown in Fig. 4. It is believed that the propagation of the electric-field-induced fatigue crack depends on the competition between two mechanisms. That is, one results in macroscopic crack growth and the other leads to produce microcracks. When the electric field is low, the macroscopic crack grows very slowly, and the long period of time in the process permits microcracks to emerge and grow. On the other hand, the microcracks near the macroscopic crack tip would weaken the electric field and thus the macroscopic crack would grow more difficult. Finally, as well known, the micro-cracks will produce a shield that impedes the propagation of the macro-crack. But for the case of high electric field, since the macroscopic crack propagated rapidly, the c 0.83E < c 0.83E > Fig. 4: Optical micrograph of a microcrack Distribution under E=1.0Ec observed by microscopy with 50 multiplication. 100 101 102 103 104 105 106 -5 0 5 10 15 20 25 30 35 40 The length of crack growth (mm) Cyclic numbers 5# 0.8Ec 4# 0.83Ec 7# 0.83Ec 3# 0.85Ec 6# 0.9Ec 11# 0.9Ec 8# 1.0Ec 12# 1.0Ec 10# 1.1Ec 9# 1.23Ec 13# 1.3Ec 14# 1.5Ec 15# 1.8Ec 16# 2.0Ec 1 2 3 4 1E-8 1E-7 1E-6 1E-5 1E-4 1E-3 0.01 0.1 1 10 da/dN=-0.11263+0.17117 (E/Ec)2 Experimental point Theoretical curve E/Ec da/dN(mm) Fig. 6: Variation of crack growth rate as a function of electric field Fig. 5: Variation of crack growth length as a function of cyclic numbers microcracks had no time to occur and grow. Besides, the electric field at the back wakes of the macroscopic crack was weakened due to the existence of
RkJQdWJsaXNoZXIy MjM0NDE=