depends on the environment. Suppose that a corrosion reaction is responsible for enhanced fatigue crack growth below the transition, i.e. below 0.1 µm/cycle in air. 0 10 20 30 0 100000 200000 300000 400000 500000 600000 number of cycles crack length in m measurements prediction, mean t³ over 3 mm prediction Figure 4. Measurements and prediction of the a-N curve in AA 2024 with 5000 underloads, underload sequence ∆K=5-16-5 (MPaŒm) at Kmax = 29 (MPaŒm) and 10 Hz. Above this crack growth rate the crack moves too fast for the corrosion assisted mechanism to take fully place, and the intrinsic fatigue crack growth rate will increasingly dominate, with a growing slanted crack surface as a result. Seawater is a more aggressive environment, and it can be expected that a higher crack growth rate than in air is needed to outrun the corrosion reaction speed. In vacuum the reverse is true and the transition will take place at a very low value of the crack growth rate. We will at the moment not speculate on the exact mechanism of the corrosion reaction, but following this rationale it is clear that the fatigue fracture situation with shear lips is the “normal” fatigue crack growth mode in these Al Alloys. When the fracture surface is flat, it is so by an environmental attack. Conclusions 1) The shear lip width seems to be a good measure for the transition from fast crack growth rate due to environmental attack to slower intrinsic true fatigue crack growth rate after the transition point. 2) The enhanced crack growth rate at lower da/dN is due to environmental attack. References 1) Zuidema, J. and M. Mannesse, A model for predicting slant crack growth in Al 2024. Engineering Fracture Mechanics 34 ,1989, 2, p.445-456’ 2) Jan Zuidema, Saskia de Vries and Adirakhmantyo Hascaryantono,The Accelerated ∆K Fatigue Crack Growth Test on AA 5083-H321 and Similitude Validation,The 13th European Conference on Fracture ECF 13, 6th-9th september, 2000, San Sebastian, Spain.
RkJQdWJsaXNoZXIy MjM0NDE=