PAPER REFERENCE: ICF100327PR FATIGUE CRACK GROWTH UNDER SIMPLE VARIABLE AMPLITUDE LOAD SEQUENCES L. P. Borrego1, J. M. Ferreira2 and J. M. Costa2 1Department of Mechanical Engineering, ISEC/IPC, 3030 Coimbra, Portugal e-mail: luis.borrego@mail.dem.uc.pt 2Department of Mechanical Engineering/FCT, University of Coimbra, 3030 Coimbra, Portugal ABSTRACT Fatigue crack propagation tests with single tensile peak and periodic overloads, Hi-Lo blocks and Lo-Hi blocks have been performed in 6082-T6 aluminium alloy, either in load control or in constant ∆K conditions. The tests were carried out using Middle-Tension specimens in a servo-hydraulic machine at R=0.05 and a frequency of 20 Hz. Crack closure was monitored in all tests by the compliance technique using a pin microgauge. The observed transient post-load step behaviour is discussed in terms of the overload ratio, ∆K baseline levels and number of intermediate baseline cycles. The crack closure parameter U was obtained and compared with the crack growth transients. Plasticity induced closure seems to be the main mechanism in determining the transient crack growth behaviour in 6082-T6 aluminium alloy following the simple variable amplitude load sequences analysed. KEYWORDS aluminium alloys, fatigue crack propagation, overloads, crack closure INTRODUCTION The 6000 aluminium alloys series are very frequently used in structural applications under service conditions that involve random or variable amplitude rather than constant amplitude loading conditions, mainly due to the fact of allying a relatively high strength, good corrosion resistance and high toughness to a good formability and weldability. An accurate prediction of fatigue life requires an adequate evaluation of load interaction effects. However, fatigue crack growth under variable load amplitudes in this series of aluminium alloys is not as well understood as in the 7000 and 2000 series. Furthermore, the amount of data available for the material studied in this work is reduced. The effects of crack growth retardation following single or multiple peak tensile overloads have been reported in many investigations simply because this type of loading can lead to significant load interaction effects [1-8]. Several mechanisms have been proposed to explain crack growth retardation, which include models based on residual stress [9], crack closure [10], crack tip blunting [11], strain hardening [12], crack branching [13] and reversed yielding [14]. The precise micromechanisms responsible for these phenomena are not fully understood. In spite of some controversy, the effect of
RkJQdWJsaXNoZXIy MjM0NDE=