-2 -1 0 1 2 Crack lenght from load step event, a-aO [mm] da/dN [mm/cycle] 10-4 10-3 10-5 ∆K1=6 ∆K2=12 ∆K1=9 ∆K2=12 ∆K1=6 ∆K2=9 (b) Figure 3: Influence of the magnitude and position of the load step in block loading. (a) high-low block, (b) low-high block. The effect of periodically applied overloads after ∆K=6 MPa m1/2 for several numbers of intermediate baseline cycles n can be seen in Figures 4(a) and 4(b). In Figure 6(a), the crack length is plotted against the number of cycles, and Figure 4(a) presents the correspondent crack growth response as a function of ∆K. For less frequently applied overloads (n>10) crack retardation is observed, while the results for overloads applied after 10 baseline cycles present crack acceleration. For a crack length of 10 mm ND are 216282, 419308 and 475538 cycles for n=100, n=1000 and n=10000, respectively. The crack retardation represents a fatigue life increase of approximately 1.8 to 4, in comparison to constant amplitude loading, when n increases from 100 to 10000. For overloads applied after 10 baseline cycles the crack reach 10 mm at 94777 cycles, corresponding to a decrease in fatigue life of approximately 20%. -2-10123456 Crack lenght from load step event, a-aO [mm] da/dN [mm/cycle] 10-6 10-4 10-3 10-5 ∆K1=9 ∆K2=6 ∆K1=12 ∆K2=9 ∆K1=12 ∆K2=6 (a) -3 0 3 6 9 12 -1 0 1 2 3 4 5 Number of cycles from first overload (x105) Crack lenght from first overload [mm] Const. Amplitude Single Overload Periodic Overloads n=102 n=103 n=104 n=101 First Overload (a) 1.E-06 1.E-05 1.E-04 1.E-03 1 1 1 1 ∆K [MPa m-1/2] da/dN [mm/cycle] 10-6 10-5 10-4 10-3 5 7 8 9 10 11 1 6 Const. Amplitude Single Overload Periodic Overloads n=102 n=103 n=104 n=101 First Overload (b) 1 2 Figure 4: Transient fatigue crack growth behaviour following periodically applied single tensile overloads. (a) crack length versus cycles, (b) crack growth rate response. It can be seen in figure 4(b) that the retardation in crack growth rate increases with ∆K for overloads applied after baseline cycles higher than 10. For overloads applied with 10 intermediate baseline cycles the acceleration in crack growth rate decreases with ∆K and for ∆K values above 10 MPa m1/2 there is
RkJQdWJsaXNoZXIy MjM0NDE=