∫ ⋅ = a x m a x dx K 0 R ( ) ( , ) σ . (1) Here the weight function, , depends only on the geometry of the component. A number of studies using the weight function have been conducted [12-19]. ( , ) m a x TABLE 1 FATIGUE CHARACTERIZATION RESULTS Model Equation Constants* Walker n R K C dN da − ∆ = − (1 ) (1 ) γ C = 2.4×10-10 N = 4 γ = 0.8 ThreeComponent − − ∆ + ∆ = 2 2 1 )) ( (1 1 ) ( 1 ( ) ) ( ( ) ) / ( 1 2 1 n c n n K R K A R K A R da dN where α (1 ) ( ) 1 1A R C R = − for 0.5 0.1≤ ≤ R 2 1( ) A R C= for 0.8 0.5≤ ≤R β (1 ) ( ) 3 2A R C R = − C1 = 1.6×10 18 C2 = 1.5×10 12 C3 = 4×10 9 α = 20 β = 0.5 n1 = 10.5 n2 = 4 Kc = 83 *The constants relate da/dN and ∆K when their units are in [mm/cycle] and [MPa√m], respectively. EXPERIMENTAL PROCEDURES Material and Specimen Preparation Hot-rolled 1080 steel plate (12.7 mm thick) was austenitized for 30 minutes at 800 °C followed by a water quench and tempering at 700 °C for 3 hours. The average ferrite grain and cementite particle sizes were 5.6 µm and 1 µm, respectively. Electro-polishing was used to remove 0.5 mm from the surfaces, without introducing residual stresses, for accurate x-ray diffraction measurements. The specimens were machined into compact tension (CT) specimens [20]. Tapered interference pins (20.8 mm/m) were inserted in tapered holes in half the specimens along the future crack plane, as shown in Figure 1. In the other half of the specimens, no pin was inserted and no hole was drilled. An interference level between the specimen and pin of 0.125 mm was achieved by pressing the pin into the specimen. 25.4 Interference pin Figure 1: CT specimen with interference pin. Initial Residual Stress Measurements The initial residual stresses were measured using x-ray diffraction [21]. A chromium rotating anode source was used with x-rays of wavelength 2.2897 Å. A tapered glass capillary tube was used to focus the x-rays to a 210 µm spot. The stress component perpendicular to the future crack faces was measured along the prospective crack line.
RkJQdWJsaXNoZXIy MjM0NDE=