ICF10B

ORAL/POSTER REFERENCE: ICF100983OR FATIGUE CRACK GROWTH WITH TENSILE RESIDUAL STRESSES Y Prawoto1 and RA Winholtz1, 2 1Department of Mechanical and Aerospace Engineering, University of Missouri 2Research Reactor Center, University of Missouri ABSTRACT Cracks were grown in specimens with and without initial residual stresses under conditions of constant applied stress intensity factor. The specimens with initial tensile residual stresses showed acceleration of the crack propagation rates. The residual stresses were converted to stress intensity factors using the weight function and added to the applied stress intensity factors using the superposition principle. The plastic zone size was also measured utilizing diffraction line broadening and a small synchrotron x-ray beam. The results show that the weight function method, combined with the three-component model of crack growth, provides a good prediction of fatigue crack propagation rates in tensile residual stress fields. KEYWORDS Residual stress, fatigue crack propagation, weight function, plastic zone, x-ray INTRODUCTION Previous studies [1-5] have found that residual stresses can increase or decrease fatigue resistance. The Paris model predicts crack growth rate as a power function of the stress intensity factor (SIF) range, but cannot predict any influence of residual stresses on crack growth rate. The Walker [6] model includes an effect of load ratio, R = Kmin/Kmax, which is affected by residual stresses. The Walker equation may be written as shown in Table 1, where da/dN is the crack growth rate, ∆K is the SIF range, and γ is the Walker exponent, which captures the R dependence. This model only captures the Stage II crack growth regime. Later models also include crack growth in Stages I and III [7,8]. The three-component (TC) model of Saxena [7] was used in this study and is also given in Table 1. The weight function method provides a powerful and simple means for calculating SIFs from the residual stresses. The SIF at any future crack length, a, is computed from the residual stress distribution, σ (x), on the prospective crack line using the relation [9-11]

RkJQdWJsaXNoZXIy MjM0NDE=