・ ○ △ □ Standard specimen( 11FY 12FY) Type- ( 11FY 12FY) Type- ( 11FY 12FY) ・ ▼ ■ ● RT Triangle wave R = 0.1 f = 0.5Hz ε 0.1 1 103 104 105 106 Total strain range t % ε∆ Cycles to Failure Nf SCS-6/SP700 Figure 2: Relationships between total strain range ∆εt and cycles to failure Nf. Also, Type-I, -II and standard specimen have different mechanical properties depending on fiber volume fraction and total number of laminates as cross section are shown in Fig. 1. Low-cycle fatigue lives curves normalized in terms of strain-to-failure εf are shown in Fig. 3. These curves have almost same slope. Reinforcement fiber ends specimen has smaller retention of strain-to-failure than those of standard specimen. In particular, there is a remarkable difference at high cycle region over 105 cycles. In a case of Type-I, the retention of strain-to-failure against the maximum low cycle fatigue strain determined at 105 cycles is the lowest, approximately 25 %. On the other hand, standard specimen kept at nearly 40 % level. Also, Type-I, that is, surface laminate layer reinforcement fiber ends specimen has smaller lives as compared with those of middle laminate layer reinforcement fiber ends specimen, Type-II. It should be noted here that TMCs have a lower design allowable in strain for low cycle fatigue, although they have also high strength characteristics. ・ ○ △ □ Standard specimen( 11FY 12FY) Type- ( 11FY 12FY) Type- ( 11FY 12FY) ・ ▼ ■ ● RT Triangle wave R = 0.1 f = 0.5Hz ε 0 0.25 0.5 0.75 1 103 104 105 106 maxε/ f ε Cycles to Failure Nf SCS-6/SP700 Figure 3: Normalized low cycle fatigue lives curves in terms of strain-to-failure εf. Changes of Stress Amplitude during Fatigue Cycle Changes of stress amplitude slightly depend on the maximum/minimum strain, strain amplitude and type of specimen. Generally, maximum stresses decreases with increasing of number of fatigue cycles, and then show the steady-state value. Finally, both maximum and minimum stresses decrease due to fatigue crack initiation and propagation, and then stress amplitude suddenly decreases near Nf cycles. Minimum stress is also reached to the negative value and the tension-compression fatigue behavior in the latter, although the strain ratio is controlled to the constant positive value. It is fundamentally resulted from the redistribution of residual stress
RkJQdWJsaXNoZXIy MjM0NDE=