Compressive Fatigue Tests. A series of compressive fatigue results have been completed at an R ratio of +10 at 10 Hz. The results are given in Table 3. The scatter in both sets of compression data is approximately 40% of the mean. This is a large number and as opposed to the tensile case the scatter had not decreased with decreasing peak load. It should also be noted that the peak loads are considerably lower in compression to produce comparable fatigue lives. This shows that compression-compression fatigue is much more damaging than tension-tension fatigue. TABLE 3. FATIGUE LIVES AT, (A) 70% AND (B) 60% OF THE COMPRESSIVE FAILURE STRENGTH. Test Cycles to Failure Test Cycles to Failure 1 4711 1 31,255 2 7064 2 63,978 3 12045 3 71,503 4 3658 4 93,855 5 6274 5 41,261 Average (mean) 6750 Average (mean) 60,370 (A) (B) Unfortuanatly, thermography could not be used during compression-compression fatigue tests due to the presence of antibuckling guides. However, post failure examination showed that the primary delamination occurred on the inner 0/+45˚ interface. This is different to the primary delamination interface in the tension tests and led to further investigations. Mixed-Mode Bending (MMB) Tests. To investigate the different delamination interfaces being highlighted in the fatigue tests a series of work has begun to investigate delamination growth rates using MMB tests. This work is at a very early stage. Initial tests have begun to investigate the 0/+45˚ interface at a mixed-mode ratio of 50% MI and 50% MII. A typical graph is shown in figure 3. This graph shows the load–displacement response to be almost linear up to a maximum load where it is assumed that the delamination begins to grow. In this case the fracture was sudden and grew quickly. This is a typical response where mode II is dominant(2). The average maximum load was 0.254 kN. The overall strain energy release rate, Gt, for this test is 408.2 J m-2. This was calculated using Eqns. 1 and 2(4), where the total G is the sum of the strain energy release rate due to mode I and mode II loading. GI = 3P2 a+ χ Ih ( ) 2 ωs ωch 3E11 1− c+b 2L − c b 2 (1) GII = 9P2 a+ χ IIh ( ) 2 4 ωs ωch 3E11 1− c+b 2L + c b 2 (2) Where E11 is the axial stiffness, a the crack length, ωc the width of the composite fracture surface, ωs the specimen width, h is the half thickness of the specimen and χΙ and χII are the mode I and mode II end rotation correction factors. Tests will now continue investigating a range of mode I / II ratios and a range of interfaces.
RkJQdWJsaXNoZXIy MjM0NDE=