ICF10B

Alongside recording the cycles to failure for each specimen tested, a series of thermographic images were also taken. The change in temperature picked up by the camera has two causes 1) hysteresis heating and 2) local heating caused by friction induced by damage in the laminate such as crack faces shearing over each other. Figure 2 shows a typical thermographic image taken during a test and a schematic of the specimens "hot spots", where there is assumed to be the highest occurrence of damage. TABLE 2. FATIGUE LIVES AT, (A) 90% AND (B) 80% OF THE TENSILE FAILURE STRENGTH. Test Cycles to Failure Test Cycles to Failure 1 6600 1 113,820 2 1900 2 43,000 3 600 3 96,800 4 5700 4 60,500 5 5800 5 47,000 Average (mean) 3920 Average (mean) 72,224 (A) (B) All of the laminates in this series of tests showed varying degrees of delamination. These delaminations were visible with the naked eye at the outer 0/90˚ interface and were present from a very early stage of the laminates life. The images showed the progressive initiation and propagation of delaminations. However, the outer 0/90˚ interface had completely delaminated along the length and breadth of the specimen by approximately 50% of laminate life in all cases. The image in figure 2 is taken after the outer layer has fully delaminated and formed a sub-laminate. However, hot spots are still visible. This suggests that as there is a continued increase in temperature in the hot spot regions and that the early initiation of delamination in the outer 0/90˚ interface has induced some further damage mechanisms in this area such as delamination of the inner 0/90˚ interface or fibre fracture. This must be the case, as the laminates failed through the area of the hottest point in all cases and the delaminations alone were not enough to cause final failure or it would have occurred when complete delamination occurred. It is important to note here that all of the tests in the two series of experiments were conducted at an R ratio of +0.1, i.e. tensile-tensile fatigue. In this case the delaminations will not cause the final failure of the laminate. However, once fatigue moves into the compressive regime, the delaminations buckle and this may cause final failure of the laminate. 59.5°C 68.0°C 60 65 Figure 2. A Typical Thermographic Image Taken During a Fatigue Test and a Schematic of the Composite "Hot Spots" During Testing.

RkJQdWJsaXNoZXIy MjM0NDE=