increasing of cycles. This has to result in a concave accumulation curve as effectively observed in the experiment. 0.00 0.01 0.02 0.03 0.04 0.05 0.06 0.0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0 S-glass/Epoxy [90 4 ,0] s laminate Present model N=102 N=103 N=104 N=105 static test Damage Strain Figure 2 – Comparison between the quasi-static and the fatigue damage evolution with strain in glass/epoxy laminate Figure 3 – Fatigue life diagram for glass/epoxy laminate (Talreja, 1987). If the maximum strain associated with the stress amplitude is below the strain threshold no damage occurs and theoretical infinite life is expected. This value is characteristic for the material and stacking sequence since the laminate lay-up gives constraint condition for the occurrence of transverse matrix cracking. On the other side, if the maximum stress is high enough to develop CDS condition in the laminate during the first cycle, no further stiffness loss will occur in the following cycles due the already occurred saturation in the damage curve. In this case failure will occur as a result of fiber failure. This scenario finds confirmation in the fatigue life diagram as proposed by Talreja and given for example in figure 3. The only objection comes from the possibility to convert constant stress amplitude data to strain. As discussed, this is only possible for stress above CDS, in the lower range strain accumulation with cycles need to be evaluated and accounted for.
RkJQdWJsaXNoZXIy MjM0NDE=