ORAL REFERENCE: ICF100321OR FATIGUE FRACTURE PLANE DIRECTION ASSESSMENT THROUGH THE WEIGHT FUNCTION METHOD Andrea CARPINTERI1, Aleksander KAROLCZUK2, Ewald MACHA2 1 Department of Civil Engineering, University of Parma, Parco Area delle Scienze 181/A, 43100 Parma, Italy 2 Technical University of Opole, Faculty of Mechanical Engineering, ul.Mikolajczyka 5, 45-271 Opole, Poland ABSTRACT In the present paper, the expected principal stress directions under proportional and nonproportional multiaxial high-cycle fatigue loading are determined by averaging the instantaneous values of the “principal” Euler angles. Such angles are employed to describe the position of the principal stress axes at the generic time instant, and the averaging procedure is performed through suitable weight functions. Three possible types of weight functions based on stress parameters are adopted and verified using available experimental results related to some metallic materials. It is shown that the fatigue fracture plane position under multiaxial loading may be established on the basis of the averaged direction of the maximum principal stress, by employing proper weight functions. KEYWORDS Multiaxial fatigue, weight function method, fatigue fracture plane INTRODUCTION According to several well-known stress-, strain- and energy-based models for multiaxial fatigue (for instance, [1-9]), the failure assessment is usually performed by referring to the “critical plane”. The concept of the critical plane, which is related to the crack initiation phenomenon, was firstly proposed by Stanfield [1] in 1935, and has been developed since then. On the other hand, from a review of fatigue test results under in-phase and out-of-phase cyclic multiaxial loading, it appears that the final fracture plane very often corresponds to: (a) the plane on which the normal stress, or strain or strain energy density attain their maximum; (b) one of the two maximum shear planes; (c) an intermediate position between (a) and (b). Case (a), case (b) and case (c) are typical for brittle materials, ductile materials and semiductile materials, respectively. The fracture plane for case (b) is one of the two maximum shear planes in which the highest normal stress, or strain or strain energy density occurs [4,6,8]. Case (a) is preferred when the ratio of the
RkJQdWJsaXNoZXIy MjM0NDE=