Improving of the fatigue lifetime prediction of screw for a large range of mean stresses A. Duval, P. Robinet, F. Trivaudey and P. Delobelle Laboratoire de Mécanique Appliquée R. Chaléat, UMR C.N.R.S. 6604 Université de Franche-Comté, 24 Chemin de l’épitaphe, 25000 Besançon, FRANCE Abstract: From a Finite Element analysis, the stress distribution in the notch of axisymmetric and highly loaded notched samples has been calculated. The samples are shaped like a thread root. We propose a simplified method of sizing screws for a large range of mean stresses.So, a local Haigh’s diagram (at the thread root) is built from experimental the Haigh’s diagram derived from smooth or notched samples. I – Introduction When trying to predict the fatigue lifetime of a screw used in a highly loaded assembly, the designer has to handle two types of difficulties. The first one is to include the effects of the mean stress on the damage. The second one, related to the geometry of the screw, is to know the influence of the notch effect on the damage in the thread root. The Haigh’s and Goodman’s diagram help us to solve the first problem when the mechanical properties of the material are known. Indeed, they give the endurance domain in which the applied and the mean stresses have to be located. The second difficulty is partly overcome thanks to Neuber’s method or the method of the gradient since they take into account the effect of stress concentration inside the thread root. Here, the method is based on an elasto-viscoplastic analysis leading to the knowledge of the local stress and strain components. Then, a multiaxial failure criterion derived from the damage rules is locally applied. This leads to a simple method of building the Haigh’s local diagram. The global method follows four steps: i) Determination for the considered steel of the elastoplastic behaviour rules under uniaxial loading with or without mean stress. ii) Determination of the damage rules leading to the rupture criteria as well as to the cumulative calculations. iii) Theoretical and experimental studies of notched axisymmetric samples shaped like a thread root. iv) Study of the fully screw-bold assemblage. We will present here the first three steps. II – Materials and experimental methods The screw steel studied here is a 38CD4 steel oil quenched from 850°C then stress relieved at 600°C for one hour. This results in a fully martensitic microstructure. Its weight composition is as follows: C % Mn % Si % S % P % Cr % Mg % Fe % 0.36 0.792 0.232 0.028 0.016 1.039 0.175 balance ( ) cos /2 2 2 1.871 1 1.197 1 1 1 a ú ú ú ú ú ú û ù ê ê ê ê ê ê ë é ÷ ÷ ø ö ç ç è æ + ÷ ÷ ø ö ç ç è æ = + q p t K K K with 2 / 1 1 1 / 1 / D d t r t K d D d D r t K q p - = = + - - = [1]
RkJQdWJsaXNoZXIy MjM0NDE=