ICF10B

RESULTS AND DISCUSSION Figure 4 presents the Weibull plots of σf and σmax,f for quasi-static and cyclic loading conditions, respectively. Also presented is a flexural strength measured under monotonic loading condition at the crosshead speed of 0.5 mm/min [5]. Despite the loading rate is 104 times lower, the σf values well agree with the flexural strength. This strongly suggests that there is no dependence of time, namely no static fatigue strength degradation. However, cyclic fatigue degradation clearly appeared in this material. ∆Pincreasing tests with different σmax,i enabled us to evaluate the cyclic loading condition under which fatigue damage nucleated. The result suggested that σmax,i influenced the σmax,f values for statistically weak specimens and thus fatigue damage developed at lower stress levels. Toughened Si3N4 dσ/dh =20MPa/hour Maximum stress at failure σmax,f Stress at failure σf MPa Cumulative probability σ max,i=100MPa 800 1.0 700 5.0 10.0 20.0 30.0 50.0 70.0 90.0 500 99.0 Quasi–static 600 σ max,i=500MPa Flexural strength σ max,i=600MPa Cyclic dσmax/dN=2.8x10 –4MPa/cycle 0.5mm/min (Urashima et al.) 4 point bending F (=(i–0.3)/(n+0.4)) % Figure 4: Weibull plots of σf and σmax,f in toughened Si3N4. Detail signal analysis demonstrated that the AE events detected contain both symmetric (S0) and antisymmetric (A0) mode Lamb wave of zero-th order. First arrival time and waveform of the S0-Lamb mode were utilized for source location and fracture dynamics study. Source location results are shown in Fig. 5 for quasi-static (a) and cyclic (b) loadings. The location was estimated by using arrival time difference of So- mode and its group velocity for the specimens with average strength for these loading conditions. The abscissa is an axial location of specimens, where the origin is a left edge of specimen. Inner span and final fracture location are indicated by broken lines and solid line, respectively. The vertical axis represents stress values at fracture. The results revealed that a few AE signals were detected at stresses just below the final fracture value near the fracture locations.

RkJQdWJsaXNoZXIy MjM0NDE=