Source rise time, ∆Tr, was estimated as 0.11 µs, which was the lower limit of our AE system. First AE signals for both loading conditions were monitored at more than 1 ks before the final fracture. These results suggest that cyclic loading enhances nucleation of small cracks. The initial crack was observed at large-grown columnar β-Si3N4 under both loadings, as shown in Fig. 8. Sizes of the β-Si3N4 were about 90µm long and 20µm wide. Similar microstructure was observed on fracture surfaces of all the specimens tested. Next computed the crack opening displacement by threedimensional finite element method (FEM) using MARC (K7-2). The model is illustrated in Fig. 9. Crack initiation location shown in Fig.8 (a) and (b) are modelled as in Fig. 9 (b) and (c), respectively. Total numbers of elements are 7168 (b) and 5488 (c). Displacements of axial direction on the tensile surface were constrained except the rectangular area surrounded by broken line. Axial displacements of the rectangular area are referred to a half of crack opening displacement and are used to determine the crack volume, ∆V, under the fracture load. The values of ∆V under quasi-static (b) and cyclic (c) loadings were calculated as 1.18x10-16 and 2.95x10-16 m3, respectively. For the quasi-static loading, the crack volumes estimated by the AE waveform matching well agreed with that produced at columnar β-Si3N4, while those for the cyclic loading were ten times smaller than ∆V estimated by FEM. The cyclic loading appears to produce discontinuous small cracks along the columnar β-Si3N4. (b) (a) Figure 8: SEM photographs of fracture surfaces under the quasi-static loading(a) and the cyclic loading(b). AE analysis shown in Figure 7 and 11 was performed for these specimens. 100µm (c) (b) (a) 100µm 100µm Tensile surface Tensile surface 5 mm Fracture surface Tensile surface Load Figure 9: Three-dimensional finite element model (a) and initial cracks modeled for the quasi-static(b) and the cyclic(c) loadings. Fatigue mechanism of the toughened Si3N4 is summarized as follows. Under the quasi- static loading, cracks with the size of large-grown columnar β-Si3N4 were initiated very quickly at the load level just below the fracture stress. Under the cyclic loading, crack initiation occurred under lower stress level with smaller initial size than under quasi-static loading. The small crack grew and led fast fracture. Cyclic fatigue damage can be regarded as the above small crack initiation, which developed under more than 100 MPa below the fracture stress level for statistically weak specimens. Early stage of the fatigue damage could not be detected by our AE monitoring system. CONCLUSIONS Both static and cyclic fatigue strength of toughened Si3N4 was investigated using new loading method and
RkJQdWJsaXNoZXIy MjM0NDE=