Oral reference: ICF 100135OR Fatigue-Creep Interactions in Solder Alloys. J E Moffatt and W J Plumbridge. Department of Materials Engineering, The Open University Milton Keynes, MK7 6AA, UK Abstract Isothermal, low cycle, fatigue testing is a popular method of evaluating behaviour under thermomechanical fatigue conditions in many applications, such as power generation and, more recently, performance of interconnections in electronic equipment. In this latter context, straincontrolled fatigue tests, involving dwells at maximum strain limits, have been performed on bulk specimens of a eutectic lead-tin solder alloy and two lead-free solders (Sn-3.5 weight percent Ag and Sn-0.5 Cu) at room temperature and 75˚C. During continuous cycling, softening occurs at each temperature. The fatigue endurance is reduced by up to one third at the higher temperature in all alloys, with Pb-Sn showing the greatest reduction. The incorporation of a dwell of 10 or 100s into the cycle generally causes a reduction in fatigue life in comparison to that observed during continuous cycling, although for the Sn-0.5 Cu alloy, a 10s hold produces an increase in life at room temperature. Cycles containing balanced dwells at maximum and minimum strain limits are the most deleterious when lifetime debits of up to fivefold are observed at both temperatures. Generally, unbalanced compression-only cycle profiles tend to be the least damaging. The stress relaxation characteristics are similar in all dwells and at both temperatures, with the eutectic Pb-Sn exhibiting 80 percent relaxation and the lead-free solders up to 50 percent after 100s dwell. Metallographic observation of sectioned specimens reveals surface and intergranular cracking which is accentuated at higher-strain ranges and temperature but not dramatically affected by the cycle shape. These findings are considered in terms of the behaviour of other engineering alloys, and their significance for life prediction is discussed. Keywords: solders, life prediction, electronics, lead-free alloys. 1 Introduction The most common cause of failure in electronics equipment is thermomechanical fatigue (TMF) of soldered interconnections. This arises due to temperature fluctuations, either from power switching or from the external environment, and to the fact that the materials which constitute the joint (solder, substrate, board) have substantially different coefficients of thermal expansion, α. For example, α for common solder (Sn-37Pb) is 22 × 10−6 K−1 and for alumina (a common substrate) it is 6.5 × 10−6 K−1. Cycling between temperature limits leads eventually to crack initiation, growth and failure, usually within the solder itself since this is the softest element of the joint. In practice, temperature excursions usually occur at different rates, and the overall cycle often contains a dwell during which the temperature is essentially constant. Continuous cycling data is of limited use for life prediction. Controlled thermomechanical fatigue testing is complex and expensive to perform, and the more common approach is to evaluate relevant mechanical properties isothermally.
RkJQdWJsaXNoZXIy MjM0NDE=