ICF10B

0 0.5 1 1.5 2 2.5 0 20 40 60 80 100 120 Pb/RT t/0 Pb/RT 0/t Pb/RT t/t Pb/75 t/0 Pb/75 0/t Pb/75 t/t Ag/RT t/0 Ag/RT o/t Ag/RT t/t Ag/75 t/0 Ag/75 0/t Ag/75 t/t Cu/RT t/0 Cu/RT o/t Cu/RT t/t Cu/75 t/0 Cu/75 0/t Cu/75 t/t Influence ratio Dwell period/seconds (Influence ratio is Nf(dwell):Nf(no dwell)) specimens tested at 75˚C, after being subjected to a 100s dwell at maximum tensile strain. Both Sn-Ag and Sn-Cu showed virtually no macroscopic cracking under the same conditions. (a) Sn-Pb 75˚C (b) Sn-Cu 75°C Figure 6. Comparison of Sn/Pb and Sn/Cu alloys after testing at 75˚C with a 100s dwell at the maximum tensile strain (magnification 200x). Further investigation is planned. In Sn-Pb, intergranular cracking occurs throughout the bulk of the specimen. At low strain ranges (0.5 and 0.75 percent) cracking is confined to the surface layer, while at higher strain ranges, cracking is apparent throughout the bulk of the specimen although the majority of damage was found near to the surface. Specimens experiencing dwell cycles exhibited a higher crack density and the number of surface cracks was reduced. Cycle profile appeared to have little effect. 4 Discussion This study has demonstrated that both lead-containing and lead-free solder alloys exhibit cyclic softening when subjected to high strain fatigue. The extent of softening is largely unaffected by temperature, strain range and the presence of dwell periods in the strain-time cycle. It is similar to that measured in a 1Cr-Mo-V steel at both room temperature and 565˚C [1]. Fatigue endurance is generally slightly lower at 75˚C than at room temperature. Insertion of hold periods in the fatigue usually causes a reduction in life by up to a factor of six for dwells of 100s duration. Post test metallographic examination reveals that fatigue produces macroscopic cracking in lead based alloys but not in lead free alloys. These findings are now considered in more detail.

RkJQdWJsaXNoZXIy MjM0NDE=