ORAL REFERENCE: ICF100572OR FIDUCIAL MARKS AS MEASURES OF THIN FILM CRACK ARREST TOUGHNESS Alex A. Volinsky1, Michael L. Kottke1, Neville R. Moody3, Indira S. Adhihetty1 and William W. Gerberich2 1 Motorola, Digital DNATM Labs, Process and Materials Characterization Lab, Mesa, AZ. 2 University of Minnesota, Dept. of Chem. Eng. and Mat. Science, Minneapolis, MN. 3 Sandia National Labs, Livermore, CA ABSTRACT Carbon fiducial marks are formed during thin film local delamination processes induced either by indentation, forming circular blisters, or by residual stress relief through telephone cord blister formations. Hydrocarbons are sucked into the crack tip during the delamination processes, outlining the crack tip opening angle (CTOA), which can be used to back calculate thin film adhesion using elastic or plastic analyses presented in the paper. KEYWORDS Fiducial marks, adhesion, fracture, delamination, crack arrest, crack tip opening angle, thin films INTRODUCTION Thin film adhesion can be measured by means of the superlayer indentation test [1-4]. Most good-adhered thin films can not be delaminated by means of regular indentation: films would rather deform plastically around the indenter by forming pileup. To prevent these problems a high modulus hard superlayer, capable of supporting and storing large amounts of elastic energy is deposited on top of the film of interest. Upon indentation a delamination blister forms around the indent, and its area is used to calculate the strain energy release rate (practical work of adhesion). This technique was shown to work with ductile metallic films (Al, Cu, Au, Cr) [2, 4-9, 15], ceramic (Ta2N) [10, 12] and polymer films [16].
RkJQdWJsaXNoZXIy MjM0NDE=