SLOW CRACK GROWTH ANALYSIS Upon blister removal with a scotch tape the crack tip residue splits into two fiducial marks, leaving one on the film and substrate sides as shown in Figure 2. The substrate fiducial mark outlines the crack tip geometry, and its dimensions can be used to extract the thin film crack arrest toughness [13, 14]. CTOA Film fiducial mark δc = 2uel rm Substrate fiducial mark Figure 2. Fiducial mark geometry. As discussed in [2, 4 and 15], brittle fracture is observed for thinner Cu films (< 100 nm) on Si substrates without a Ti underlayer. The majority of blisters in these films are buckled, so the crack is mostly under Mode I loading. This allows us to use the elastic crack tip opening displacement expressed for the plane stress tensile loading [17]: 8 el K u ( r ) E r π = (1). AFM measurements of the fiducial mark on the substrate side provide the height, δc=2uel(rm), and the half width of the mark, rm (Figure 2), so KI can be expressed as 32 I c m K E r π δ = (2). From equation (2), for δc = 8 nm and rm = 1 µm one finds KI = 0.3 MPa⋅m1/2. This is close to the 0.33 MPa⋅m1/2 value calculated from the actual G measurements (~0.9 J/m2) for thinner Cu films using K=(GE)1/2 for plane stress [2, 4, and 15]. Since the analysis is purely elastic, it indirectly proves that there is not much plastic energy dissipation at the crack tip for thin Cu films. Previously we also employed a plasticity-based slow crack growth approach based on the Rice, Drugan and Sham (RDS) analysis of the tearing modulus, T0 [18] to show a similar result [13]. One can obtain a simple expression for strain energy release rate in terms of the crack-tip opening angle (CTOA in Figure 2):
RkJQdWJsaXNoZXIy MjM0NDE=