ICF10B

FINITE DEFORMATION ENERGY RELEASE RATE COMPUTATIONS IN A STEADY ROLLING TIRE Sanjay Govindjee Structural Engineering, Mechanics, and Materials Department of Civil Engineering University of California, Berkeley Berkeley, CA 94720-1710, USA ABSTRACT The recent well publicized failures of the Firestone ATX/AT tires has brought to light the poor state of research into the basic physical causes of such failures and the poor state of research into analytic methods suitable for analyzing such failures. The essence of problems of this nature lies in the finite deformation fatigue fracture of elastomers at large strains. The definition of failure criteria is further complicated by the issue of material aging. The computational problem is rather demanding due to the truly 3-D nature of the tire system under load. Finding the failure forces (the singular energy momentum tractions) is made challenging by the spinning reference state normally utilized in computational tire analysis. A true analysis of such problems demands that one address all of these issues; this paper focuses on one aspect of this problem – viz., the formulation of suitable analytic expressions for the computation of the crack tip driving forces in spinning tires. KEYWORDS Tire mechanics, Energy release rates, Finite deformation INTRODUCTION In assessing the durability of tires a common physical phenomena to be investigated for steel belted radial passenger tires is belt edge cracking. The important physical quantity to be measured or computed here is the energy release rate. As is well known, energy release rate is the physical quantity introduced by Eshelby to characterize the driving force upon a singularity in the elastic field [2, 3] and it is intimately related to the pioneering fracture studies by Ingles [7], Griffith [6], Irwin [8], and Rivlin and Thomas [15]. In the context of fracture, this driving force or energy release rate is often associated with the J-integral criteria [14, 1]; under common conditions the two are of course synonymous. The application of these basic notions turns out to be a modestly complex undertaking for a spinning tire. If we leave aside the experimental aspects, we have available to us a variety of methods for the computation of energy release rates given mechanical loads. For the tire, one is for practical reasons restricted to methods associated with numerical approximations such as the finite element method[18]; see e.g. [11, 9] for a discussion on computational methods for energy release rates. As noted by Govindjee [4] these methodologies have

RkJQdWJsaXNoZXIy MjM0NDE=