ICF10B

Figure 4: stress-strain relations of Al Σ9 grain boundary (a) xx direction (b) yy, zz directions 0.0 0.1 0.2 0.3 -4 -2 0 2 4 6 8 10 12 28% tensile strain (a) xx stress (GPa) 0.0 0.1 0.2 0.3 -2 0 2 4 6 8 10 tensile strain (b) yy zz stress (GPa) At the strain of 28%, the stress is maximum, about 9.9GPa. After the strain of 28%, the stress decreases. In real case, the size of yy, zz direction should decrease when the unit cell is stretched according to xx direction. Because the Poisson’s ratio is not considered in this tensile test in order to save the computational time, there exists the stress also in the yy, zz directions (see Figure 4(b)). TABLE 1 THE MAXIMUM STRESS σmax AND THE CORRESPONDING STRAIN εmax εmax σmax (GPa) Al boundary 28% 9.9 fcc Al [001]a 20% 11 experiment b 2.9% 2.25 a ref.[4] b ref.[18] Table 1 shows the maximum stress σmax and the corresponding strain εmax of Al single crystal by both the experiment and the calculation. The maximum stress of Al boundary in our calculation is a bit lower than that of [001] direction of Al single crystal calculated by Deyirmenjian et al.[4], i.e., 11GPa. This means Al grain boundary still bonds strongly. The maximum stress of single crystal of Al fiber tested by Gane[18] is about 2.25GPa, much smaller than that by this calculation. This should be due to: 1. Poisson’s ratio is not considered in the calculation. The presence of Poisson’s ratio generally decreases the maximum stress. 2. Dislocation is not considered in the calculation. In real crystals, the motion of dislocation usually results in a reduction in strength. Furthermore, the changes of the charge density and the bond length with the increase

RkJQdWJsaXNoZXIy MjM0NDE=