obtained efficiently using the conjugate-gradient technique proposed by Bylander, Kleinman and Lee[16] with the Kerker mixing scheme[17]. The plane wave energy cutoff is 15Ry, and 32 k points in the Brilliouin zone are used. The electronic structure is determined by a real space grid of points. 256×64×32 In the tensile test, a uniaxial tensile strain is introduced into the stable configuration. The supercell is stretched by a small increment in xx direction that is normal to the boundary plane. The length of the yy and zz direction is fixed in order to save the computational time. This means Poisson’s ratio has not been considered. The atomic positions are changed by uniform scaling. Then all the atoms are relaxed according to the Hellman-Feynman forces until all the forces are less than 0.15eV/Å. The total energy and stress tensor are calculated. This cycle is iterated until the stress reaches the maximum value. During the tensile test, the symmetric property of the system is naturally preserved. RESULTS AND DISCUSSIONS Figure 2 shows the change of the total energy with the increase of the tensile strain. It can be seen that the total energy decreases before the strain of 1%. After the strain of 1%, the total energy increases. This should be due to the boundary expansion after the initial relaxation (see Figure 3). Therefore there exists the compressive residual stress in the unit cell. When the unit cell is stretched, the residual stress will be relaxed at first, thus the system becomes stable and the total energy becomes lower. Figure 2: Total energy change with the tensile strain in the ab initio tensile test of the Al Σ9 grain boundary 0.0 0.1 0.2 0.3 0.4 -355.0 -354.5 -354.0 -353.5 -353.0 -352.5 -352.0 1% strain total energy (Ry) Figure 3: The relaxed configuration of the left half part of layer B and A in the unit cell. G, F, E, H and J correspond to the atoms marked in Figure 1. The atom positions before the relaxation are represented by the smaller circles, in which the unfilled and the half-filled ones represent the atom positions of B and A layer, respectively. The bigger circles indicate the atom positions after the relaxation. 0 3 6 9 12 0 3 6 (A) (A) J H G F E The stress-strain curves of Al grain boundary are shown in Figure 4. Only those of xx([221]), yy([ ), zz([110]) direction are plotted. The stress in other directions is so small to be ignored. Figure 4(a) shows the stress-strain relation in xx direction. At the strain of 3%, the stress on the unit cell becomes positive, thus 3% is set as zero strain in the stress-strain curve. It is shown that the stress increases with the increase of the strain. 114]
RkJQdWJsaXNoZXIy MjM0NDE=