cubic SiC by the same scheme. In both calculations the supercell is extended by a small increment and then relaxed to its ground-state configuration using the first principles pseudopotential method. The total energy and the average stress are obtained for each level of extension. By iterating this cycle, the maximum stress σmax can be obtained at the corresponding strain εmax. This should correspond to a real tensile test at zero temperature. In this paper, we perform an ab initio tensile test on Al Σ9 grain boundary in order to investigate how aluminum containing the grain boundary fails as it is pulled apart at zero temperature. COMPUTATIONAL METHOD The unit cell is constructed as shown in Figure 1. Al Σ9(221)/[110] tilt grain boundary is formed by rotating grain by 38.94˚ along the [110] axis, and (221) is set as the boundary plane. The coincidence site lattice (CSL) unit cell on the boundary plane is defined by 0 3 2 a [114] 2 and 0 2 a [110] 2 . The size in the [110] direction is set twice that of the CSL, i.e. 2 0a . In the [221]direction two symmetric boundaries are introduced to make the periodicity. The distance between the grains is determined by that the atom density in boundary is the same as that of the unit cell in the ref.[6]. Total energy, atomic forces and averaged stresses can be obtained quantitatively[7] by the ab initio plane-wave pseudopotential method[8] based on density functional theory (DFT)[9-10] with local density approximation (LDA)[11]. The pseudopotentials of Al is constructed[12] using Troullier-Martins scheme[13]. The separable form by Kleinman and Bylander[14] with the p orbital as the local component is used. The lattice parameters calculated by the pseudopotentials are 3.95Å for fcc Al, which is in good agreement with the corresponding experimental value of 4.02Å(0K)[15]. The electronic ground state is Figure 1: The cross section of zz[110] direction of the unit cell, Al Σ9(2-21)/[110] tilt grain boundary. There are four (110) atomic layers, A, B, C and D. The length of three sides are 28.469Å(xx), 8.379Å(yy) and 5.586Å(zz), respectively. There are 84 atoms in the unit cell. F, G, E, H and J are the atom positions of B layer marked for later discussions. The dark-grey spheres indicate the atoms of B(or D) layer in the unit cell. The light-grey spheres indicate the atoms of A(or C) layer in the unit cell. (Å) (Å) xx yy 0 5 10 15 20 25 0 4 8 J F H G G.B. G.B. E zz[110]
RkJQdWJsaXNoZXIy MjM0NDE=