ICF10B

CLASSICAL MD SLIP SIMULATION OF - AND -Si3N4 Four types of shear deformation are modeled, to examine the properties of the slip system, which are, -f1 101g<11 20>(Case 1), -f10 10g<0001>(Case 2), -f10 10g<0001> (Case 3), and -f10 10g<1 210>(Case 4). Cases 1 and 2 correspond to the possible primary slip systems which were reported by Suematsuet al.[10], and Niihara and Hirai [11], respectively. Case 3 corresponds to the primary slip system which was reported by Evans et al.[12], Kawahara et al.[13] and Milhet et al.[14]. Finally Case 4 corresponds to the secondary slip system reported by Kawahara et al.[13]. Snapshots of the atomic arrangement in the model under shear deformation are shown inFigure3.Theslidingdirectionsarefromlefttorightofthe gures.Theslidingspeed was 10 m/s. The black and gray circles represent nitrogen and silicon atoms, respectively. Onlythoseatomswhichhaveacoordinationnumberthatdi ersfromthatoftheperfect crystal are shown. Theshearstresswascalculatedasthesumofalltheatomicforcesofthe xedatoms along the shear direction divided by the initial area of the slip plane. The shear strength is estimated from the maximum shear stresses as 25 GPa(Case 1), 20 GPa(Case 2), 18.5 GPa(Case 3), and 17 GPa(Case 4). In Case 1, no plastic deformation in the sliding direction was observed (Figure 3). However, Suematsu et al. [10] asserted that this direction is one of the possible slip systemsfromKnoophardnesstesting. Thisdiscrepancymaybeduetoane ectof hydrostatic stress produced by Knoop hardness testing. However, slip deformation in Case 2, Case 3, and Case 4 was observed. In particular in Case 3 slip progresses by dislocation movement. The width of the dislocation is estimated to be approximately 8 A. Case 1 Case2 Case 3 Case4 Figure 3: Atomic arrangements under shear deformation

RkJQdWJsaXNoZXIy MjM0NDE=