ICF10B

CLASSICAL MD CRACK PROPAGATION IN AND -Si3N4 The MD crack propagation analysis was performed to determine the critical stress intensity factor. Cubic cells in which the a and c axes of - and -Si3N4 are along the x and z directions, respectively, were used. The cells contain approximately 10,000 atoms and the dimensions for the x, y and z axis were approximately 9 nm, 9 nm and 1.2 nm, respectively. Initially, a crack was inserted and the crack front was placed along the z axes. The initial atomic displacements were taken from the mode I linear elastic solutions corresponding to a stress intensity factor KI.Followingthistheatomiccon gurationswas relaxed for 1.2 ps, except for the outermost atoms within 0.6 nm of the cell boundaries. If the crack tip did not move after the relaxation process is complete, the critical stress intensity factor KIc can be estimated fromKI. Four cases were calculated, i.e. for the crack tip in the prism and basal plane of each - and - crystal. The results are listed in Table 1. Reimanis et al.[15] estimated the KIc for - crystal as 1.5 2.0MPa pmfrom the Knoop tests and for - as 1.3 1.4 MPa pm from the theoretically calculated bond energy. The results presented in this paper are in good agreement with the estimations of Reimanis et al. However, it is possible that our estimated of KIc is somewhat smaller than the true KIc value because of the under estimation of stress and ideal strength by the 3-body potential. Table 1: Critical stress intensity factors of silicon nitride crystal type crack plane crack front KIc MPa p m (0001) [01 10] 1.5 (01 10) [0001] 1.3 (0001) [01 10] 1.7 (01 10) [0001] 1.4 CONCLUSION The intrinsic tensile and shear strength of -Si3N4 was found to be 74GPa and 28GPa, respectively. It is found that the 3-body potential used to calculate results for Si3N4 are of an acceptable accuracy. Furthermore, the primary slip system of - and - Si3N4 was determined as f10 10g<0001>. The critical stress intensity factors for several mode I cracks were also calculated and are in good agreement with the data reported by Reimanis et al. REFERENCES 1. W. Y. Ching, Y-N. Xu, J. D. Gale and M. Ruhle (1998) \Ab-Initio Total Energy Calculation of - and -SiliconNitrideandtheDerivationofE ectivePairPotentials with Application to Lattice Dynamics ",J. Am. Ceram. Soc., 81, pp.31893196. 2. R. Belkada, T.Shibayanagi, M. Naka and M. Kohyama (2000)\Ab-initio Calculation of the Atomic and Electronic Structure of -Silicon Nitride",J. Am. Ceram. Soc., 83, pp.2449-2454. 3. J.A.Wendel and W.A.Goddard III (1992) \The Hessian Biased Force Field for Silicon Nitride Ceramics: Predictions of Thermodynamic and Mechanical Properties for - and -Si3N4",J. Chem. Phys., 97, pp.5048-5062.

RkJQdWJsaXNoZXIy MjM0NDE=