ICF10B

deposited grid [6]. It allows accurate determination of elastic strains as well as measurements of large plastic strains. In this paper, we describe the technique and review the results obtained on Ag and Cu thin films, as well as Ag/Cu multilayers [7]. The dependence of the yield stress on the layer thickness is analyzed in terms of the Hall-Petch relation and compared to the results from hardness tests. The rate of work hardening strongly increases with decreasing layer thickness [2]. These results are used to interpret the trends observed in the fracture stress, the ductility and the fracture surface morphology. EXPERIMENTAL METHODS Thin film samples were deposited through a dogbone-shaped mask on glass substrates by electron beam deposition in high vacuum. Typical dimensions were a thickness of 3 µm, a gauge length of 10 mm and a width of 3 mm. The bilayer repeat length of the multilayers varied from 3 nm to 3 µm, depending on the number of layers. The thickness of the Ag and Cu layers was equal. Both the pure films and the multilayers had a strong <111> texture. computer feedback to keep stress constant copper stage enclosed load cell ilm heat exchanger for air cooling of load cell screen with diffraction pattern (n, 0) motor-driven micrometer x-y translation stage laser measure stress measure strain two-dimensional position sensor (0, n) f grip mirror slide #1 slide #2 lens 400 300 200 100 0 Stress (MPa) 1.4 1.2 1.0 0.8 0.6 0.4 0.2 0.0 Strain (%) Ag/Cu 1 bilayer λ/2 = 13900 A 11 loading cycles Ε 0.2% Yield Stress Figure 1: Schematic diagram of the tensile tester for thin film samples [7]. A thin, very compliant, two-dimensional square grid of photoresist dots (see Figure 4(a) for an oblique view) was deposited on the films by photolithography. The films were then removed from the substrate and placed in the grips of the tensile apparatus of Figure 1. The differences between the positions of two spots of the diffraction pattern produced by a

RkJQdWJsaXNoZXIy MjM0NDE=