ICF10B

other metallic multilayers [9] and has been attributed to changes in the dislocation dynamics when the number of dislocations in the pile-ups near the grain boundaries becomes small [10]. Importantly, however, the yield stress and hardness continue to rise with decreasing grain size even at the smallest sizes; no softening is observed. Work hardening The work hardening rate, θ = dσ/dε, of the stress-strain curves for the multilayers in Figure 2 has been analyzed [2] using the formalism developed by Kocks [11]. The initial work hardening rate is 10 to 20 times higher than the maximum work hardening rate, θΙΙ, in single crystal silver. This can be explained by the introduction of an additional set of dislocation obstacles with an effective spacing, D. (3) ( )2 3 II II sat M G b KM 2 D 2D α θ θ θ σ σ σ   = + −  +    where M is the Taylor factor, G the shear modulus, b the Burgers vector, and σsat the saturation stress of the single crystal; α and K are constants. D decreases with decreasing grain size but is substantially smaller than d. The dislocation structures built up as a result of the presence of interfaces could decrease the effective obstacle spacing provided by the layers [2]. Fracture and ductility As shown in Figure 2, the fracture stress of the multilayers increases with decreasing λ as long as macroscopic yield can be observed. Values as high as 700 MPa have been measured. The plastic strain at fracture decreases continuously with λ and is only 0.16% in the strongest samples. For the shortest repeat lengths (λ < 80 nm) no macroscopic plastic strain is observed. In a few samples, with large repeat lengths, plastic strains up to 2.3% have been measured. Figure 4: Scanning electron micrographs of the fracture surfaces of (a) a Cu thin film, (b) a Ag/Cu multilayer (bilayer repeat length 40 nm), both fractured in tension. Figure 4(a) shows the fracture surface of a pure Cu film broken in the tensile tester. The overall ridge shape and the "vein" in the middle are clear indications of a simple, macroscopic ductile fracture. Figure 4(b) shows the fracture surface of a multilayer with a

RkJQdWJsaXNoZXIy MjM0NDE=