ICF10B

ICF100767OR FLUID-STRUCTURE INTERACTION RELATED ASPECTS DURING THE GROUTING OF CRACKS IN CONCRETE H.N. Linsbauer Institute of Hydraulic Structures, Vienna University of Technology, Karlsplatz 13/222, A-1040 Wien, Austria ABSTRACT Fluid Structure Interaction (FSI) processes in cracked systems generally may be assigned to “Hydraulic Fracturing”, which in the field of petroleum-engineering is well understood by mathematical and numerical descriptions and utilisation in situ. However there is a further important aspect related to this technique but opposite in the objective – grouting of cracked concrete structures under the aspect of full rehabilitation. Unfortunately uncontrolled grouting may sometimes cause an opposite effect, e.g. creating of new cracks or further crack propagation. Based on the understanding of the closely coupled process between the injected fluid and the structural response especially the Stress Intensity Factor development at the crack front may serve as an efficient control parameter during the grouting procedure. KEYWORDS Concrete, cracks, grouting, repair, fluid structure interaction INTRODUCTION A certain category in the wide field of fluid structure interaction processes also has to be considered in civil engineering in all cases where an elastic structure in dynamic motion is in contact with a fluid at rest or vice versa. A wide class of problems stretching from flow induced vibrations in hydraulic engineering [1] to added mass concepts in dam engineering [2] may be assigned to this discipline. The injection procedure during the grouting of cracks in concrete structures also may be seen as an interaction between fluid penetration and structural response and basically is comprehended by the disciplines of fluid mechanics, structural mechanics and fracture mechanics. The closely coupled process is characterised by the time dependent fluid penetration as a function of the crack width and the herewith associated pressure development causing a further alteration of the cross section. In addition the stress intensity at the crack front, accountable for the stability (reliability) of the grouting procedure, is directly related with. The physical-mathematical formulation of these complex circumstances ever since has been a matter of special concern in the field of petroleum-engineering under the aspects of “hydro-fracturing “, to achieve optimal production conditions. Representative for the multitude of relevant treatises, Lit. [3,4,5,6] including recommendations for further readings, is specified. The grouting process of cracks mathematically may be exhibited similar to that one representative for hydraulic fracturing but with an essential difference concerning the crack (tip) behaviour. Opposite to the “hydraulic driven fracture” - a continuously moving fluid-fracture system – care has to be taken, strictly to avoid any instability of the system during grouting. Within this contribution a model both for a plane and a penny-shaped crack configuration is presented to comply with this demand.

RkJQdWJsaXNoZXIy MjM0NDE=