The functions f, f1, f2 were constructed on the basis of the results of the numerical solving the appropriate elasticity problems [12]. The size of the limit equilibrium crack is defined by the condition (5) Ic I K K= It is apparent from Eqs. (3.2) and (3.3) that a porous material subjected to the uniaxial compression is fractured by main cracks intersecting the volume being loaded along the principal compressive stresses, since the inequality KIa > KIR is valid for any a < 3R. This statement is valid also for mechanisms of brittle fracture of heterogeneous materials with different stress concentrators [9-11]. It is in good agreement with the experimental data concerning the brittle fracture of rocks [12]. Main compression discontinuities represent one of the basic forms of brittle fracture of heterogeneous materials. For a porous body subjected to the biaxial compression, main cracks are bounded in length. The occurrence of the unstable phase of the development of the main discontinuity formed by a chain of pores implies that the necessary condition for the generation of a higher-rank structure is satisfied. To satisfy the sufficient conditions, it is necessary that the perturbation of the stress field in the neighborhood of the main crack would initiate the unstable development of another main crack at a distance from the former crack. Depending on the parameters of the initial structure (for example, on the porosity) and loading condition, the stress field perturbation can initiate a fracture site in a short-range or long-range neighborhood of the main crack. The conditions for the generation of the fracture site near the tip of an arrested crack are most favorable in the neighborhood of a tensile crack at a distance of an order of magnitude of 2L from the crack tip [13]. At this distance, the shear perturbation zone covers two interacting pores (Fig. 1b). The condition for these pores to join together provides the sufficient conditions for an increase in the structural rank to be satisfied. The latter conditions imply the relations 2L K ), ) K ( K K ( Ia 1,2 2 2 IR 1 1 IR Ic = σ+∆σ + σ−∆σ ∆σ ≈± , ) R f (n), ) ( K ( 2 1 1 1 1 IR σ +∆σ = σ +∆σ (6) n (22 21n ) 5 8.4n 13.4n ) Rf (n), f (n) ) ( K ( 1/3 1/3 2/3 1/3 3 3 2 2 2 2 IR − − + = σ −∆σ = σ −∆σ If the boundary conditions specified in terms of stresses (σ1, σ2) are fixed, then the relations (6) define the basic parameters of the crack echelon in the volume being loaded. These parameters are the lengths of isolated main cracks in the echelon and the distance between parallel main cracks. The configuration of the echelon (the relative arrangement of main cracks) depends on the conditions of interaction of neighboring cracks in the echelon. Note that the location of the fracture site in the neighborhood of the main fracture and the direction of the development of the next main fracture can be different and determined by stress fields in the long-range zone. Echelon structures in ice cover Necessary and sufficient conditions of structure of fracture formation can be provided by different mechanical processes. As an example let us consider a type of largescale structures in the ice cover-formation of an echelonlike system of faults in thin level ice under uniform tension [14]. The velocity of growth of a single fault in a viscoelastic thin plate on a hydraulic foundation is changed with nonmonotone manner at increasing the fault length [8]
RkJQdWJsaXNoZXIy MjM0NDE=