ICF10B

alloy steel in the observed inclusion of eighteen samples, four examples was the nitride titanium, and one example was the manganese sulfides. On the other hand, eleven examples were nitride titanium in the bearing steel in the observed inclusion of sixteen samples, four examples were the alumina, and one example was unknown. In both steels, the fatigue fracture has been initiated at the interface of inclusion and matrix. The peculiar fracture area (GA) formed to surrounding of the inclusion develops remarkably under the low stress amplitude and in the long life region. Y. Murakami [10,11] suggested the high possibility that hydrogen takes part in the formation of this GA, but clear evidence has not been obtained yet. FRACTUREMECHANICSAPPROACH The stress intensity factor range, ΔKini , corresponding to the defect size which are evaluated on the square root of the area of inclusion or GA, were calculated using the following expression suggested by Y. Murakami et al.[13]. , where σat is a stress amplitude value which acts on the position of the crack origin. Figures 8 show the relation ( ) area K at ini π σ 0.5 ∆ = between ΔKini and cycles to failure, Nf. for both steels. In both results, the tendency thatΔKini corresponding to the inclusion size decreases with the increase of Nf is obtained. On the other hand, ΔKini corresponding to the GA size almost indicates a constant value without depending on the increase of Nf. CONCLUSION 5

RkJQdWJsaXNoZXIy MjM0NDE=