ICF10B

ICF100158OR MATERIAL AND EXPERIMENTAL PROCEDURE: The patented and cold worked pearlitic material with the following compsition and homogenous properties throughout its length in the form of coiled strip was supplied. C: 0.8%, Si 0.18%, S 0.015%, P 0.007%, Mn 0.55%. The same material was hardened at 790oC and tempered at 418oC for one hourt to give almost identical strength values corresponds to a hardness of 431 + 16 D.P.N. To make fracture toughness specimens, strips 84x19x1mm were polished down to 30 grade emery paper and then dpped into 70% pb & 30% Sn molten lead tin solder held in graphite crucible at a temperature of 232oC. In this way a uniform layer of solder was maintained on each strip. In order to get the required geometry for the fracture toughness specimens, eight such strips were riveted together and then hot pressed at a temperature of 250oC for one hour. A pressure of 635 MN/m2 was maintained until the temperature dropped to room temperature. The composite specimens were machined and then notched according to the specification. Fig. 1 shows the specimen geometry. For precracking, a high frequency vibraphone was used. All conditions satisfied for pre-cracking were fulfilled, (Brown, 7, 1970). FRACTURE TOUGHNESS TESTING: Fracture toughness tests were carried out on an Instron machine at a cross head-displacement rate of 0.05cm/min using the pre-cracked specimens and specimens were mounted in pin type grips loaded in tension. A 1000 ohm BISRA clip guage was located across the notch of the specimens using brass sadles glued on the X-Y recorder was subsequently used for analysis and measurement of fracture toughness. Fig 3 shows the load displacement records, which full-filled all conditions for valid KIC. The results are shown in Table 1 and Table 2. MICROSCOPY: To study the modes of failure of the laminates electron fractography was carried out by using EM6G microscope and Cambridge Scanning Electron Microscope. Such details are shown in Fig. 3 (a, b, c) and Fig. 4 (a, b, c) for soft soldered composite laminates tested at a cross head displacement rate of 0.05cm/min, with pearlitic and martensitic and martensitic structures. This includes delamination in the region of slow crack growth, cracking of pearliest and inclusions in the region of fast fracture and ductile failure in the region of fast fracture in either case. TABLE 1. FRACTURE TOUGHNESS TEST RESULTS OF S.E.N., SPECIMEN MADE FROM 0.8% CARBON MANGANESE STEEL WITH PATENTED AND COLD WORKED SOFT SOLDERED LAMINATES TESTED IN AIR. Specimen No. Displacement Rate. Tagent Line (Degree) P5 (A) Pkg KQ MNm-3/2 1. 2. 3. 0.05 0.05 0.05 51 51 51 1530 1530 1530 140.75 140.75 140.75 Mean KQ = 140.75MNm-3/2

RkJQdWJsaXNoZXIy MjM0NDE=