ICF1001038OR Fig.7. Relation between crack length Fig.8. Relation between crack length and deflection for specimen A. and deflection for specimen C. specimen A was also presumed to promote crack growth. The experimental results have led to the possibility that more serious crack growth might occur in a component subjected to a higher degree of corrosion damage. Hence, the fracture behavior of the corroded structure should be considered for the risk assessment to minimize the risk of catastrophic failure. Ductility of the Annular Plate Poor ductility of the annular plate in the transverse direction was assumed to promote crack growth. Fig.10 shows the relationship between the fracture strains and stress concentration factors of tensile specimens[2] for both the transverse and longitudinal directions. The fracture strain in the transverse direction was about a half of that in the longitudinal Fig. 9. Relation between total crack Fig.10. Relation between fracture strain length and deflection. and stress concentration factor. direction, and was found to be a small value under a high stress concentration factor. Thus, the crack growth behavior was certainly accelerated by low ductility of the annular plate. Also, poor ductility of the annular plate was well explained from a detailed fractographic examination. A typical fractograph of the annular plate is shown in Fig.11. The fracture surfaces are composed of equiaxed dimple area and featureless zone that is supposed to be caused by cracking and decohesion of non-metallic inclusion. The greater portion of the fracture surface is covered by featureless area. An average value of area fraction covered by dimple for 14 views was found to be a small value of 22% because of low ductility of the annular plate. The relationship between dimple area fraction and fracture strain of the tensile specimen in the transverse direction was developed in Fig.12. Dimple area fraction was found to be a value of about 50% for the unnotched specimen, and decreased linearly with decreasing fracture strain. It is because the higher tri-axial stress state developed in the sharply notched specimen promoted the occurrence of featureless zone. Using the above relation, the fracture strain of the annular plate can be estimated to be a relatively low value of 40% from the dimple area fraction of 22%.
RkJQdWJsaXNoZXIy MjM0NDE=