matrix is 66.25 J/m2. Based on the relationship: , we obtain the matrix critical stress intensity factor = ) /(1 2 2 m mc m mc K E G ν− = mc K 0.486MPa m. 0.008 η 0.000 0.005 0. σ/E 0.00 0.02 0.04 0.06 0.08 0.10 Crack tip ∆a 0.000 0.002 0.004 0.006 0.010 0.012 KI (MPa*m1/2) 0 1 2 3 4 5 η=10, κ=0 η=10, κ=500 η=15, κ=500 η=15, κ=1000 Fig. 3. Fracture resistance curves for several values of parameters and κ. x1/R0 010 0.015 0.020 0.025 η=10, κ=500 η=15, κ=500 η=15, κ=1000 Fig. 4. Fiber stress ( σ /E) along the crack-line (x1/R0) for several values of parameters η and κ Figure 3 shows typical R-curves for different debonding energy and interfacial frictional resistance. An increase in means an improvement in debond toughness and an increase in κ, normalised by f 1σ 0 / E R , means an increase in frictional sliding resistance. It is clear that crack initiation is delayed by increasing . Fracture toughness is enhanced as crack advances at a relatively large slope because of the dominant effect of fibre-bridging. An increase in the frictional sliding resistance also increases the fracture toughness. Due to the complexity of the pullout process, the effects of fibre sliding at the debonded interface cannot be separated in the bridging law. However, it is reasonable that an increase in fracture resistance takes place at large κ. There is a transition of the R-curve from an initial rising part to a steady-state in which the length of the bridging zone does not change with subsequent crack extension. This transition occurs when the fibres at the receding edge of the bridging zone begins to break. The very slight rise of crack-resistance in the steady-state region is caused by kinetic effect since extremely large CPU time is required for lower loading rate than that used. η Increasing the interface strength will accelerate fibre breakage due to the stress elevation in the fibres ahead of the crack-tip. The nett effect is a reduction in the fibre pull-out displacement. If we take case 4 in Fig. 1 with η=10 and 1 2δ δ = cf for a very strong interface, the steady-state toughness is much lower but slope much larger at the initial stage than that with the same η, Fig. 3. It is unwise hence to increase the interface strength, as the admissible inelastic deformation accompanying fibre sliding is severely curtailed. There are optimal interface properties to obtain maximum fracture toughness. As fibre stress ahead of the crack-tip is not affected by the amount of crack advance at the stage of steady-state crack growth, the distribution of fibre stress at incipient fibre breaks can be taken as typical for a set of given material parameters. Fig. 4 shows distributions of normalized fibre stresses for three cases studied. With increasing interface strength and frictional resistance, the maximum fibre stress also increases. This corresponds to 0.06, 0.084 and 0.095 for the three cases. Although a large κ can increase the maximum stress in the bridged zone, it decreases rapidly to the same level as low κ ’s at the crack-tip, as frictional sliding does not come into effect ahead of the crack-tip.
RkJQdWJsaXNoZXIy MjM0NDE=