TABLE 1 MOLDING CONDITIONS Resin temp. Mold temp. Injection Speed (deg. C) (deg. C) (%) 180 200 220 200 200 200 40 40 40 80 40 40 30 30 30 30 10 90 Run 1 2 3 4 5 6 Double Torsion Test Fracture behaviour was investigated in double torsion (DT) test. The specimens were cut from the injection molded plates shown in Fig. 2(a). The specimens without weld lines were called Ref and those with a weld line were called Weld, respectively. A sharp pre-notch was introduced just at the pin side of the weld line for Weld as shown in the circle marked A in Fig. 2(b). A pre-notch was also introduced at an equivalent position for Ref. The fracture tests were conducted at a crosshead speed of 0.1 mm/min. at 23±2 ℃ and 60±5% with universal test machine, Autograph AG-50kNE, from Shimadzu Co. The specimen was supported by steel spheres (φ 11 mm) at each corner of the specimen and loaded by two spheres positioned over the notch (Fig. 3). Figure 2: Specimen for double torsion test. Pre-notch (a) (b) A 0.5 0.5 2.5 Detail of A Figure 3: Schematic diagram of double torsion test.
RkJQdWJsaXNoZXIy MjM0NDE=