ICF10B

RESULTS AND DISCUSSION Fig. 4 shows typical load-displacement curves for both Ref and Weld obtained from the DT test. They exhibited a stick-slip mode. At start of the test the load rose linearly until the pre-notch opens, and rapid fall and linear increase in load were observed alternately. They were found to correspond to unstable crack propagation and crack arrest, respectively. In addition, slow crack propagation was observed with gradual falls in load. Fig. 5(A) shows the micrograph of the whole fracture surface of Ref. The fracture surface could be classified into two regions, mirror regions with no marks, and rough regions with ripple marks, indicating that the crack propagated in two kinds of manner. Tracing the crack propagation in the (A) Ref (B) Weld (c) (b) (a) Rough region Tension side Compression side Rough region Mirror region (f) (e) (d) Tension side Compression side Pre-notch 3.0mm Weld Ref Figure 4: Load-displacement curves of Ref and Weld in DT test. Arrows indicate slow crack propagation region. 1.5 Crosshead displacement (mm) 0 0.5 1.0 Load (N) 20 40 60 80 0 100 Figure 5: overviews of fracture surfaces. (A) Ref and (B) Weld. Six rectangles (a), (b), (c), (d), (e) and (f) correspond to magnified images in Figure 6.

RkJQdWJsaXNoZXIy MjM0NDE=