The actual strength is dependent on the level of pre-stressing of the glass and the configuration. Ultimate strengths in bending of 80 MPa with a Young's modulus of 50 GPa and a fracture strain of 25% can be achieved reliably. This is similar to the mechanical properties of some aluminium alloys. Figure 5: Beam specimen after testing RESEARCH INTO COMPOSITE PLATES In a similar way composite plates were produced. The number of layers, number segments in a glass ply and method of overlapping is a design variable that allows for tailoring of the properties. The plates were tested by supporting them at the four corners and loading them in the centre until cracks started to form. Cracks were always started at the edges of the glass segments in the tensile bottom layer. At a given stress level the cracks were arrested after several mm of growth. Increasing the stress resulted in limited crack growth followed by crack arrest. Study of the arrested cracks under load with microscopes showed that debonding took place over a length of approximately 25COD at any point in the crack length with variations between 1 and 35COD depending on bonding quality. Properties are again dependent on the configuration but similar to those found for beams. In addition the plates have a significant antipenetration capability. Figure 6: Drawing of arrested cracks at edges of segments in composite plates
RkJQdWJsaXNoZXIy MjM0NDE=