Also, decreasing the spacing of the wires in the sensor reinforces the system in a manner similar to fibers reinforcing a composite, also depicted in Figure 4. Therefore, the sensor is less prone to delamination if the coating thickness does not exceed 0.166 a0, and the wire spacing is less than 1.10 a0. The second mode of failure investigated was fracture of the sensor system due to the fatigue cracking of the component. The sensor material is quite brittle, e.g. a lower fracture toughness, KT2, in comparison to the component material, KT1, and will therefore fracture at a lower stress. The key factors in preventing fracture of the sensor are the position of the wire in the mesh and the size of the crack as it approaches the sensor. If the wire is placed too close to the surface, the insulating layer will simply crack and fall off as the fatigue crack propagates through the part, while the wire remains intact. If the wire is placed too close to the part, then the fatigue crack will break through the insulating layer between the part and the wire causing delamination to occur at the interface. Therefore, the wire in the sensor must be embedded within the coating a minimum of 20% of the coating thickness from either side, as illustrated in Figure 5. This minimum must be then raised to 25% to provide adequate electrical insulation between the component and wire. CONCLUSIONS The fracture mechanics modeling has shown that it is possible to design a patterned coating on the engine component surface which will be adherent at the stresses and temperatures normally present in operation, and will fracture in a controlled manner when, and only when, there is an underlying crack in the disk. The model has predicted an upper boundary of c/a0 = 0.175 for the total coating thickness, of which at least 25% must be the protective layer covering the conductive grid. Although the model Figure 5: Effect of wire placement on impedance and initiation of delamination. 0 0.5 1 1.5 0 0.2 0.4 0.6 0.8 1 h/c KT / KTd Acceptable Impedance Figure 4: Effect of coating thickness and wire spacing on delamination. 0 0.5 1 1.5 2 2.5 0 0.5 1 1.5 2 2.5 3 3.5 s / a0 KT / KTd c / a0 = 0.538 c / a0 = 0.166 c / a0 = 0.176
RkJQdWJsaXNoZXIy MjM0NDE=