Displacement (mm) Force (N) ∆a' = ∆a + rp 0 20 40 60 80 100 120 140 160 180 0 1 2 3 4 5 ∆a' = 0.5 mm ∆a' = 1 mm ∆a' = 1.3 mm ∆a' = 2.5 mm ∆a' = 3 mm ∆a' = 4.2 mm ∆a' = 5.3 mm JImax [kJ/m2] ∆aÕ = ∆a + rp (mm) 0 2 4 6 0 5 10 15 20 25 30 35 Region of validity Crack tip blunting Plastic zone develops Crack is advancing Figure 2 (3.11): Multiple specimen J-integral test on α−PP/ 15 vol.% EPR, a/W = 0.5, tested at room temperature and at a displacement rate of v = 0.001 m/s [1] Linear elastic fracture mechanics (LEFM) analysis with plastic zone correction From LEFM one derives for a compact tension (CT) specimen a stress intensity factor KI: KI = f(a/W) Fmax B W (3) where Fmax is the maximum force applied to the specimen and f(a/W) a correction function, which depends on sample geometry and is tabulated [6]. In the range of validity of LEFM KI corresponds to KIc and a plot of Fmax over BW1/2/f should give a straight line through the origin. If the criteria of LEFM are not met, an apparent KImax is obtained from Eqn. 3 (Figure 3i, bottom curve). In that case KImax will depend on sample and crack geometry as for instance on a/W (Figure 3ii). The main reason for such dependence is generally the presence of a small confined plastic zone rp at the crack tip. In the classical models by Irwin [Irwin] for an elasto-plastic material and Dugdale [Dugdale] this has been taken into account by substituting the crack length a by aeff = a + rp. The size of rp is derived from respectively a yield or a line zone criterion [2]. For a rubber modified polymer Gensler [5] has used a volume strain cri- terion. Grein [1] uses a different procedure to correct for confined plasticity, she proposes to determine rp by numerical iteration in such a way that all data of a corrected plot Fmax over BW1/2/f(aeff) fall on a line through the origin (Figure 3i, upper curve). The apparent K obtained for a ductile (β-crystalline) -50 0 50 100 150 200 250 300 350 400 0 20 40 60 80 100 120 Fmax [N] rp = 0 mm rp = 2.22 mm (i) 1 2 3 4 5 6 0.2 0.6 rp = 0 mm rp = 2.22 mm (ii) aeff/W [-] B W1/2/ f [mm]3/2 KImax [MPa.m1/2] Keff KImax Figure 3: (i) Determination of the size rp of the plastic zone by an iteration procedure (see text); (ii) evolution of Keff of an unmodified β-PP as a function of aeff/W [1]
RkJQdWJsaXNoZXIy MjM0NDE=