The EWF concept is based on the assumption that the total work of fracture, Wtot, is dissipated in two distinct regions at the crack tip, in the so-called process zone or inner fracture zone (We), and in an outer plastic zone (Wp). A test protocol has been developed by the European Structural Integrity Society (ESIS) [3]. The specific work of fracture, wtot, is obtained by normalizing Wtot with the fracture surface A = l. t (given by the sample thickness, t, and the so-called ligament length l): wtot = we + βwpl (1) The quantity we is referred to as the specific essential work of fracture (in kJ/m2) and the parameter wp is called the specific non-essential or plastic work of fracture (in MJ/m3). A plot of wtot versus the ligament length results in a straight line, which intersects the ordinate at we = 9.05 kJ/m2 (EWF plot, Figure 1i). An analysis of the stress-strain curve (Figure 1 ii) shows that the energy values obtained for crack initiation and for propagation, both contain contributions to we and wp. Thus, despite the linearity of the EWF plot, there is a notable ambiguity concerning the fracture energy. It should be noted, however, that the term βwp gives a rather sensitive account of the capacity for plastic deformation, thus indicating the effects of e.g. aging much earlier than the yield stress [5]. 0 50 100 150 200 250 0 10 20 30 40 Extrapolation Wtot (mJ) y = 1.57x + 9.05 R2 = 0.984 0 10 20 30 40 50 60 70 80 90 0 10 20 30 40 50 60 B (W-a) [mm]2 wtot (kJ/m2) (i) Force (N) (ii) Displacement [mm] A B Figure 1: EWF plot (i) and stress-strain curve (ii) of a ductile polymer (β-PP/ 15 vol.% EPR) [1]. Two possible criteria for the determination of Wtot are indicated, a fixed displacement (A) and the minimum of force (B). J-Integral The J-integral concept has proven its usefulness for a variety of polymers. It relates the dissipated energy J to the crack advance ∆a. J can be calculated for a cracked sample from: J = ηU B(W−a) (2) where U is the surface under the stress-strain curve, B specimen thickness, and (W-a) the effective ligament length. The factor η depends on sample geometry [3]. Figure 2 represents the results of a multiple specimen test [1]. The method is not only laborious because of the large number of specimens (which could be avoided by the single-specimen J-integral method [3]) but it is also ambiguous because of the difficulties to determine ∆a with sufficient precision in a non-transparent, tough material.
RkJQdWJsaXNoZXIy MjM0NDE=