ICF10B

strip yield model is used to determine plastic stretches in the plastic zone so that a system of elements may be created to determine the crack closure, see Fig.2. The strip yield model has been extended to solve the crack growth problems in residual stress fields created by the plastic yield (Wang, 1999 [4]). Fig.3 shows a verification of the strip yield model when gross yield occurs for a pure bending specimen, Fig.3 (a). Under a gross yield condition, see the stress curve with triangle symbols in Fig.3 (b), the non-linear finite element analyses (FEA) showed that the strip yield solution is a very good approximation for the plastic stretches in the plastic zone when a crack is created. Fig.3 (c) shows a comparison between the results of FEA and the strip yield model for the crack surface profile and pure plastic stretches in the plastic zone. When the plastic stretches are used in the strip yield model as shown in Fig.2, reasonably accurate solution of crack closure may be realised for the analyses of PYF problems. S S a c -500 -400 -300 -200 -100 0 100 σres, MPa 0 1 2 3 y, mm 4 205 145 -150 170 275 225 195 Maximum stress, MPa -200 -100 0 100 200 σop, MPa 0.01 0.1 1 FALSTAFF spectrum σmax=205 MPa Without post yield With post yield a, mm (a) (b) (c) Fig.4: Residual stress analyses for a single notch specimen. APPLICATIONS To demonstrate the necessity and advantage of the PYF analyses, several cases are considered. The first case is for the fatigue life analyses of a single notch specimen, shown in Fig.4 (a), subjected to various spectra and load levels. Most of the fatigue load levels create plastic yield at the notch as shown in Fig.4 (b) for the resulting residual stresses. The PYF effect is particularly strong when a spectrum loading condition are considered. Fig.4 (c) shows an example of the crack closure solution for one case of FALSTAFF spectrum loading with and without post yield effect. When PYF occurs, the crack closure will occur at higher levels due to the residual compressive stress field created by the tensile dominant spectrum. The PYF affects strongly the fatigue life of many small load cycles. The fatigue life may be reduced, on the other hand, for a compressive dominant spectrum. 0 50 100 150 200 250 300 σmax, MPa 1E+4 1E+5 1E+6 1E+7 1E+8 Cycles TWIST FALSTAFF GAUSSIAN R=0.5 R=0 R=-1 R=-2 0 50 100 150 200 250 300 σmax, MPa 1E+4 1E+5 1E+6 1E+7 Cycles TWIST FALSTAFF GAUSSIAN R=0.5 R=0 R=-1 R=-2 (a) (b) Fig.5: Comparison of conventional and post yield analytical fatigue lives for various load and spectra. Fig.5 shows predicted fatigue lives compared to test results for various fatigue load spectra and levels. There are reasonable agreement between predictions and tests, see Fig.5 (a). The PYF effect is obvious as shown in Fig.5 (b) (the curve close to the legends) compared to the analyses when the PYF effect is not considered (the curve away from the legends). The PYF effect can be positive or negative depending on the spectrum

RkJQdWJsaXNoZXIy MjM0NDE=