ICF10B

type (tensile or compressive dominant loading). For GAUSSIAN spectrum for example, the PYF effect is negligible since the spectrum is symmetrical at relatively high stress level. PYF problems are not limited to high loaded details as the example as shown in Fig.4. Residual stresses in the detail may increase the local stress concentration and create PYF problems even when the applied load is low. An example is shown in Fig.6 for a type of cruciform welded specimens with different surface conditions [5]. The specimen has a rather high stress concentration at the as-welded state, but the stress concentration is low for the TIG-dressing condition. There are severe residual stresses due to the welding as shown in Fig.7 for the through-thickness residual stresses measured by the neutron diffraction method for different surface conditions. 0 2 4 6 8 -0.5 -0.25 0 0.25 0.5 y/w Mode I stress on surface TIG AW 0 2 4 6 8 0 0.2 0.4 0.6 0.8 1 x/t Through-thickness Mode I stress TIG AW x y Fig.6: Stress concentration in a cruciform welding specimen. Measurements of the same specimen after various fatigue cycles are also shown in the figure. The measurements, in agreement with the analyses, showed a possible elastic shakedown condition existing after the initial plastic yield, see Fig.7. At the shakedown condition, the stress concentration combined with the residual stress field creates a much stronger PYF effect as the fatigue results in Fig.8 shows for a comparison between various predictions and fatigue test results for a symmetrical spectrum loading condition. The fatigue lives are nearly two orders of magnitude shorter due to the tensile residual stress. Compared to the PYF effect as shown in Fig.5, the residual stress has a much stronger effect, see the comparison in Fig.8. 0 200 400 600 800 σyy MPa 0 2 4 Thickness, x mm Change of residual stress for As weld specimen 6 Model 5x10 5 cycles 2x10 5 cycles Initial Surface Center 0 200 400 600 800 σyy MPa 0 2 4 6 Thickness, x mm Change of residual stress for TIG dressed specimen Model 2x105 cycles 5x105 cycles 10 5 cycles Static Load Initial Surface Center (a) (b) Fig.7: Neutron diffraction measurements of residual stresses before and after fatigue loading at cruciform welding specimens for as-welded and TIG-dressing condition For a more complicate case when a mechanical rivet fastener joint is considered as shown on the right side of Fig.9 [6]. The fastener joint has not only a high stress concentration, contact and friction will also be strong at the joint. The right side of Fig.9 shows some stress-strain responses under the fatigue loading condition for various levels of fatigue loads. An elastic shakedown condition is observed in the finite element results even though the stress-strain behaviour is different. Similar analyses are performed for the fatigue life analyses according to the shakedown stress condition. The analytical results are compared to the test results in Fig.10. In the same figure, the analytical results are also presented for a linear elastic fracture mechanics (LEFM) analysis based on forces computed from a

RkJQdWJsaXNoZXIy MjM0NDE=