impact energy were measured. The critical cleavage events in precracked and notched were identified using metallographic sectioning methods. EXPERIMENTAL PROCEDURE The test material was a bainite steel (WCF-62) in quench-temper condition. The chemical composition is shown in Table 1. The microstructure is tempered bainite. The yielding strength and hardening exponent were measured using round tensile specimen in the temperature range of –196oC to 20oC. TABLE 1 COMPOSITION OF THE MATERIAL (%) C Si Mn Ni Cr Mo V B S P 0.06 0.23 1.36 0.36 0.19 0.21 0.03 0.0017 0.009 0.02 Three-point bend specimens with a/W ratio of 0.23, 0.45 and 0.72 were tested at –196oC and –100oC. Crack tip opening displacement (CTOD) at unstable fracture (dc) was obtained according to ASTM standard E1290-93. The impact energy was measure using standard Charpy V-notch test from –100oC to 20oC. To investigate the fracture mechanism in both the precracked and notched specimens, the critical fracture event was identified using metallographic method. The critical fracture event is considered as the most difficult step in the process of cleavage fracture from crack initiation to propagation. For the threepoint bend specimen, sections were cut perpendicularly to the front of the precrack tip in the specimens unloaded at 95-98% fracture load at which the specimens were regarded in a critical condition. In this study, double-notched four-point bend specimen with the same notch dimensions of Charpy V-notch was used to investigate the critical event in the notched specimen at –196oC. In the double-notched specimens, when cleavage initiates from one notch, the survived notch must be in the critical state due to the same stress condition. The sections are then cut across the survived notch to observe the arrested cleavage microcracks which are shorter than the critical length for unstable propagation. The fracture surfaces were observed using scanning electronic microscope (SEM) and the composition of particles located in cleavage initiation sites was analyzed using energy dispersive analysis of X-ray (EDAX). RESULTS AND DISCUSSION Fracture Mechanism of Precracked Specimens at –196oC The experimental result of the three-point bend (COD) tests at –196oC is summarized in Table 2. P is the failure load, dc is the critical crack tip opening displacement, and KIC is stress intensity factor. TABLE 2 EXPERIMENTAL RESULTS OF COD TESTS AT –196oC a/W P (kg) dc (mm) KIC (kg/mm3/2) 0.23 1240 8.32 136.7 0.23 1580 13.9 176.9 0.45 600 7.6 130.2 0.45 620 7.5 129.8 0.45 680 9.8 148.0 0.45 690 9.5 145.7 0.72 280 9.0 142.4 0.72 320 9.2 143.9 0.72 330 8.9 141.7
RkJQdWJsaXNoZXIy MjM0NDE=