uniform electrical loads and in-plane and anti-plane mechanical loads. Using Stroh’s formalism [1-3], the general two-dimensional solution can be written in the form ( ) ( ) ( , , , , , , , T 2 32 22 12 2 T 1 31 21 11 1 T 3 2 1 ,2 ,1 2 D D u u u σ σ σ σ σ σ ϕ = = = = − = = + = + Σ Σ u Σ ψ Σ ψ Lf Lf ψ u Af Af 1 ) (1) where i ij i D u , , and σ ϕ are the displacements, electric potential, stresses and electric displacements, respectively. The two 4×4 matrixes, A and L, are related to the material properties, with denoting their elements, repectively. The analytical function vector, , is determined by the remote loads and the boundary conditions. ij ij L and ( )T ) A 3 4 4 ) ( ( ) z f z z = f 1 1 2 2 3 ( ) ( ) ( f z f z f INSULATING CRACK Zhang et al. [3] obtained the solutions for an insulating elliptical cavity using the exact boundary conditions, traction-free, surface charge-free and continuity of electric potential, along the cavity surface. The results depend greatly on the ratio of β α/ , where α is the ratio of the minor semi-axis, b, to the major semi-axis, a, of the ellipse, and β is the ratio of the dielectric constant of the cavity to the effective dielectric constant of the piezoelectric material. When the cavity shrinks into a slit crack, there are three limiting cases, respectively corresponding to / 0→β α for an electrically permeable crack, →β α/ a finite nonzero value for general cases and →∞ β α/ for an electrically impermeable crack. Only the two cases of electrically permeable and impermeable cracks are discussed in the present paper. From these solutions, the energy release rate for the two cases can be expressed in terms of the intensity factors at the crack tip 2a ⊗ ⊗ ⊗ ⊗ ⊗ ⊗ • • • ∞ ∞ 1 1 or i i ε σ ∞ ∞ 1 1 or D E ∞ ∞ 2 2 or i i ε σ ∞ ∞ 2 2 or E D • • • Fig. 1 A crack in an infinite piezoelectric medium under combined remote loadings. ( ) 4 TK B BK + = J , (2) where with the components being the stress intensity factors of the three modes, K ( T III I II D K K K K = K ) I, KII and KIII, and the electric displacement intensity factor, , respectively. B is a Hermitian matrix, DK = = − 44 3 2 1 1 B i B B B B AL , (3) The upper left-hand block B1 is a 3×3 matrix and the lower right-hand element B44 is scalar. For stable materials, B has the following properties [1, 2] 0 , 44 T 3 2 < = B B B . (4) Electrically permeable crack The electrically permeable boundary conditions correspond to / 0→β α and lead to the intensity factors
RkJQdWJsaXNoZXIy MjM0NDE=