DEFECTS DESCRIPTION The Ti6Al4V titanium alloy, widely used in aeronautic and astronautic industries, has the following composition (wt %) : Al 6, V 4, Ti bal. The powder metallurgy alloy microstructure consists of α (hcp) grains with two morphologies, globular or lath shape, embedded in a β (bcc) phase (~10% volume fraction). The potential impurities likely to be found are the following ones (including the composition of the principal elements in wt %) : In718 (Cr 19, Fe 18, Nb 5, Mo 3, Ni bal.), In625 (Cr 20, Mo 8, Nb 3.5, Ni bal.), Astroloy (Cr 15, Mo 5, Al 4, Ti 3.5, Co 1.5, Ni bal.), FeNi (Fe 70, Ni 30), Stellite 21 (Cr 26, Mo 5.5, Ni 2.5, S, 1, C 0.25, Co bal.). After the compaction HIP cycle, followed by a classical heat treatment in order to control the titanium alloy microstructure, the defects present several layers due to cross-diffusion of chemical elements as shown in Figure 1. In these micrographs, displaying the chemical contrast (BSE), the surrounding laths correspond to Ti6Al4V material still affected by diffusion and not yet to the bulk material. By changing the contrast in the bright centre of the defects, more layers can be observed. SEM chemical analysis shows that for the three Ni base alloys analysed, the composition of the initial powder particle completely vanishes, mainly due do Ti diffusion from the matrix and Ni diffusion to the matrix. In the Co base alloy, a similar phenomena is observed with more Ti and a lack of Co in the centre. By contrast, the centre of the FeNi defect remains almost unaffected by diffusion (less than 2% Ti is observed). Of course, these considerations are linked to the unknown size of the initial defect particle of powder, which is at least the diameter of the central layer after compaction. In625 Stellite 21 100 µm 100 µm 100 µm 100 µm FeNi Astroloy Figure 1: Overall aspect of the pollutions To identify the phases responsible for damage initiation, thin foils have been prepared with care in a In718 pollution for TEM observations (Figure 2). The centre of the pollution is composed of a bcc phase corresponding to Tiβ rich in Cr, and a Ti2Ni fcc phase with grains of a few µm. The surrounding large layer
RkJQdWJsaXNoZXIy MjM0NDE=