ICF10B

(a) In625 (~4.9%) (b) In625 (~1.8%) (flat specimen) Figure 5: Different stages of damage on In625 pollutions (horizontal loading direction) Interrupted tests have been performed to analyse damage initiation in presence of such impurities. In Figure 5, different stages of the crack evolution are presented for a In625 pollution. The crack initiates in the centre (Figure 5a) of the defect probably composed of the following brittle phases : Tiβ and Ti2Ni (as seen in the In718 TEM analysis). Moreover, due to the chemical compositions observed, a Laves phase Cr2Ti [2] is also expected depending on the diameter of the initial powder. The crack then propagates first in a brittle fashion through the Tiβ layer and finally reaches the unaffected Ti6Al4V material (Figure 5b) where it grows between the α laths. From the very beginning of the damage process, the crack is observed perpendicular to the loading direction. Due to the similarities between In625 and In718 chemical composition and fractographies, the same type of propagation is expected in In718. (a) FeNi (1.8 %) flat specimen (b) Stellite (3%) Figure 6: Damage initiation in FeNi (left) and Stellite (right) – (vertical loading direction) By contrast, for FeNi (Figure 6a) and Stellite (Figure 6b), the crack never propagates through the defect centre. In both cases, the Tiβ brittle layer is broken perpendicularly to the loading direction and the crack pass round the centre. DISCUSSION The main conclusion derived from these experiments are presented in Table 2. Interrupted tests at the Ti6Al4V yield stress showed that in the case of FeNi and Stellite, a crack is already present at that stress level. Due to the low ductility observed in presence of In718 defects, it is expected that crack initiation occurs also for an overall stress close to the yield stress. By contrast, in the case of In625, crack initiation is observed after the yield stress.

RkJQdWJsaXNoZXIy MjM0NDE=