ICF10B

TABLE 2 MAIN CONCLUSIONS ON THE DEFECTS INFLUENCE ON DAMAGE pollution astroloy In625 FeNi Stellite In718 Initiation - σ > YS σ ≤ YS σ ≤ YS σ ≤ YS ? Induced damage Min. defect radius - R > 100µm R > 50µm TE decrease - small strong strong strong By analysing many samples of In625 and Stellite, a minimum size of the defect centre necessary to induce accelerated damage has been defined. Due to diffusion, the size of the initial defect particle was certainly greater. However, it appears that a pollution of Stellite roughly twice smaller than a In625 one is sufficient to induce damage. From the above results, we can propose the following fracture processes for the several types of impurities. For In718 and In625, the critical stress for cleavage is first reached in one of the intermetallic compounds present in the central part of the defect. The small grains as well as the polyphase microstructure explain the rough aspect observed on the fractography. In a second step, due to stress concentration at the crak tip and increase of the overall stress, the critical stress in the Tiβ is reached leading to the brittle propagation seen in Figure 4. In718 is found more dangerous than In625 probably due to a particular intermetallic with a lower cleavage stress. The damage stages of FeNi and Stellite are quite different. From the micrographs performed on interrupted tests, it appears that the first stage corresponds to the brittle rupture of the Tiβ layer. The crack then propagates towards the centre following the interface between the centre and the surrounding layer. This mechanism can explain the effect of temperature by the low sensitivity of the cleavage critical stress σc with temperature. If σc is considered constant with T, an increase of the testing temperature leads to a decrease of the stresses magnitude in the whole defects. Above 50K, the damage mechanism in the unaffected Ti6Al4V is initiated before cleavage in any of the brittle layers of the defects. The next step is to quantify the critical stress of the observed brittle layers since in the literature these intermetallics compounds have only been studied at high temperatures. ACKNOWLEDGEMENTS The authors are thankful to the Centre National d'Etudes Spatiales for partial financial support of this work, and to I. Chu and S. Pachot for SEM and TEM contributions. REFERENCES [1] Ambard, A., Guétaz, L., Briottet, L., and Guichard, D. (1999) IN : Proc. Of the 9th World Conference on Titanium, pp. 608-615, Saint Petersburg, Russia. [2] Van Beek, J.A., Kodentsov, A.A. and Van Loo, F.J.J. (1998) J. Alloys Comp. 270, 218.

RkJQdWJsaXNoZXIy MjM0NDE=