ICF10B

ICF1008870R FRACTURE STRENGTH OF CERAMIC NOZZLE BLADES UNDER THERMAL SHOCK CONDITIONS Takao Mikami 1, Koichiro Tagashira 2 and Masakazu Obata 3 1 Ishikawajima Inspection & Instrumentation Co., Ltd., Yokohama, JAPAN 2 Ishikawajima-Harima Heavy Industries Co., Ltd., Tokyo, JAPAN 3 Kanazawa Institute of Technology, Ishikawa, JAPAN ABSTRACT The fracture strength of ceramic turbine nozzle blades is evaluated under instantaneous thermal shock working conditions by a newly developed high-temperature thermal cycle cascade tunnel. The facility was designed to be produced an unsteady thermal stress more than 400MPa for ceramic blades and to confirm the fracture strength. The tunnel operates at a constant speed, with heated gas and ambient temperature air, and has the capability to perform thermal fatigue tests. The objective models are SiC and Si3N4 blades with a chord length of 33.6 mm and an aspect ratio of 1.05. The heating and cooling conditions of the test blade were confirmed with steady and transient measurements in the hot gas of 1,400 ºC and ambient cooling air. The measurements include surface temperature distributions on the both sides of the blade. The thermal stress distribution of the test blades was predicted by a finite element method under experimental boundary conditions. Typical results of the transient analysis for the test blades are presented and it is shown that the maximum thermal stress occurs at the leading-edge region of the test blades. The two SiC test blades were fractured at a maximum stress range of 550MPa, but any Si3N4 blade was not fractured up to 630MPa. A typical fracture mode of ceramic turbine nozzle blades under instantaneous thermal shock conditions is observed and the fracture mode is presented. KEYWORDS Thermal shock, Ceramics, nozzle, Fracture probability, Ceramic gas turbine INTRODUCTION Gas turbines have attractive characteristics such as low environmental pollution, fuel versatility and high specific power. An increase of the turbine inlet temperature (TIT) enables a significant improvement in the thermal efficiency of a gas turbine. Using metallic materials, further increase in TIT will not be expected without additional cooling air. One of the most effective means to solve this problem is the application of ceramics to gas turbine components. The application of ceramics to the hot section components enables a significant increase of TIT and the reduction of heat losses through the elimination of blade and nozzle cooling, resulting in improved thermal efficiency and fuel savings. The ceramic gas turbines are, therefore, attractive in terms of the conservation of energy resources and the protection of the environment [1,2]. In order to apply ceramic turbine blades to a gas turbine, we have to evaluate their resistance to thermal shock. Especially turbine nozzles are directly exposed to the high-temperature gas from a combustor and they will meet a high thermal shock in case of gas turbine trip and stop operating conditions. For this purpose, we developed a high-temperature thermal cycle cascade tunnel to simulate the actual gas

RkJQdWJsaXNoZXIy MjM0NDE=