ICF10B

turbine operating conditions and silicon carbide (SiC) and silicon nitride (Si3N4) nozzle blades were evaluated. This paper describes the developed apparatus and thermal stress evaluation procedures and test results. THERMAL CYCLE CASCADE TUNNEL AND TEST NOZZLES To simulate the actual operating condition of gas turbines, we adopted air and helium flows to a rapid cooling system. The apparatus was designed to enable a cyclic thermal shock testing and consists of a high-temperature gas generator (over 1,400℃), a heating and cooling block of ceramic turbine nozzles, a high-speed traverse unit of the nozzles, a control system and a data acquisition system. The main schematic of the apparatus is shown in Figure 1 in which four nozzles are arranged in a retainer block made of fire- brick as shown in Figure 2. The block is heated up to a required temperature and then the block is rapidly traversed to the cooling air side at a constant speed. An instantaneous thermal shock test is thus completed. In case of cyclic thermal shock testing, following the above procedure, the block is traversed to the heating side contrary and the procedure is repeated. Considering the uniformity of the flow and temperature distribution, two inside nozzles among four nozzles are evaluated in the tests. After the nozzles were heated up to 1,400℃, they were cooled by the cooling air. The velocity of the cooling air was increased step by step. The thermal stress induced in Si3N4 nozzle is lower than that of SiC because of the difference of the material properties. In case of the Si3N4 nozzles helium gas was also used for the cooling in order to increase the thermal stress. Unsteady temperature distributions of the nozzles during the thermal shock test were monitored by scanning type and fiber type pyrometers. Figure 1: Thermal shock testing facility for turbine nozzle Figure 2: Turbine nozzle retainer block

RkJQdWJsaXNoZXIy MjM0NDE=