ORAL Presentation No. ICF101022OR EFFECT OF REINFORCING PARTICLE MORPHOLOGY ON THE TENSILE RESPONSE OF 6061/SiC/25p DISCONTINUOUSLY-REINFORCED ALUMINUM Jonathan E. Spowart2 and Daniel B Miracle1 1Air Force Research Laboratory, Materials and Manufacturing Directorate, AFRL/MLLM, Wright-Patterson AFB OH, USA 2 U.E.S. Inc., Dayton OH, USA ABSTRACT In order to study the effect of particle morphology on the tensile response and fracture behavior of Discontinuously-Reinforced Aluminum (DRA), two P/M 6061/SiC/25p materials were fabricated using established powder blending, compaction and extrusion techniques. One of the materials contained abrasivegrade SiC (F-600) whilst the second material was fabricated using a lower aspect ratio grain, selected to give an overall higher bulk density (HBD) in the as-blended form. Care was taken to ensure that each material contained the same size and volume fraction of SiC particles, and to ensure that each material experienced an identical processing route. Mechanical testing was completed at ambient temperature, in order to measure the effect of particle morphology (F-600 vs. HBD) on both the elastic and plastic tensile response of the DRA. Extensive microstructural and fractographic analyses were also carried out on the as-processed and as-tested specimens, using optical and electron microscopy. Future work includes both analytical and numerical modeling to relate the mechanical behavior to microstructural differences between the two materials. KEYWORDS Discontinuously-Reinforced Aluminum, DRA, SiC, ductility. INTRODUCTION Over the last decade, DRA materials based on the Al-SiC or Al-Al2O3 systems have been receiving increasing industrial interest[1, 2]. This can be attributed to more precise process control leading to wellcharacterized materials with better mechanical properties than those previously available, allowing them to be used in fracture-critical applications for the first time. The currently-available commercial DRA materials show great promise in terms of their specific stiffness (modulus ÷ density) when compared to conventional aluminum alloys, and are therefore seen as excellent candidates for further development as structurally efficient metallic materials. For example, an increase in specific stiffness of 1.5 x can be obtained using a reinforcement volume fraction of 50 %. However, this level of ceramic reinforcement typically reduces the ductility of the DRA around 20–60 % of the ductility of the matrix alloy, as shown in Figure 1. Evidence from previous studies[3-6] suggests that angular particles can produce high localized hydrostatic stresses in response to external loads, especially at the particle corners. These localized stresses have been linked to void nucleation in the matrix adjacent to the particles during tensile loading. The incorporation of a less-angular reinforcement phase is therefore seen as a potential route to improving the ductility of DRA materials, by reducing the propensity for tensile failure by the commonly-observed void growth and coalescence mechanism. The present work can therefore be considered a first step toward the ultimate goal of producing a more ductile, high specific stiffness DRA.
RkJQdWJsaXNoZXIy MjM0NDE=